CONTENTS Safety inflammation page 4 installation Unpacking . . page © Positioning page 5 Water inlet .. page 5 Water drainage page 5 page 6 Electrical connections page 7 Getting to know your machine . . page 8 Control panel page 8 Washing hints page 9 Wash care symbols page 10 Energetic wash cycles . page 11 Gentle wash cycles page 12 Which detergent to use? page 13 Sandwich form? page 13 Useofdetergentand additives .. ..otter s page 13 Using your machine Washing 4.
SAFETY INFORMATION It is most important that this instruction hook should be retained with the appliance for future reference, Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the new owner can get to know the functioning of the appliance and the relevant warnings. ‘These warnings have been provided in the interest of safely. You MUST read them carefully before installing or using the appliance.
INSTALLATION Unpacking Before starting the machine up, the transport security bolt must be removed as follows: You are advised to keep all the packaging for re-use in case the appliance has to be transported again. 1. Unscrew and remove the three rear transit bolts {using a spanner). 2. Lay the machine gently on its back, making sure that the hoses are not squashed, We suggest & polystyrene angle bracket from the packing is placed on the floor before tilting it back to avoid the hoses being squashed. 3.
important Before connecting up the machine to new pipework or to pipework that has not been used for some teems, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Whether discharging into a sink or a standpipe, check that the end of the drain hose is neither oo high nor too low. The top of the curve in the hose's 40 mm end should be no more 500 mem min 850 mm max | inside dia min than 85 cm (34" and no less than 50 cm 500 mm min {207} above floor level.
ELECTRICAL CONNECTIONS WARNING: THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should this safety measure not be observed. # the plug that is tutted fo your appliance is not suitable for your socket cutie, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut oft plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into 2 13 amp casket in another part of your home.
GETTING TO KNOW YOUR MACHINE Contra Manet DELTA wanna oyt Showroom LI Impetus wt mam Detergent dispenser drawer The dispenser drawer has 3 compartments marked with the following symbols: Rewash symbolism indicates the compartment for the rewash detergent. Wash symbol {ILJ indicates the compartment for the main wash detergent. Fabric softener * indicates the compartment for the fabric conditioner. This compartment is fitted with a removable filter. To open the dispenser, pull the handle gently. 2.
WASHING HINTS Do NOT overdrive the machine, Weigh the laundry the first fow times you use the appliance.
WASH CARE SYMBOLS Wash care labels inside garments recommend how to launder your clothes with the best results The care labeling code is in fine with care labeling used in the rest of Europe. The symbols used make it easy to select the correct programmer on your washing machine.
PROGRAMMED FOR COTTON AND LINEN Recommended load: max.4.5 kg (10Ib) people COMPARTMENTS crammer PROGRAMMED TO USE DESCRIPTION OF SOIL ok required) DAL POSITION Rewash WHITES WITH . -‘3:9 Heavy Wash at 60°C REWASH A Rinses. pin ' Rewash (o0 WHITES WITH Wash at 90°C (button REWASH Heavy A+@ 2 Rinses. Spin WHITES Wash a1 60°C INTENSIVE WASH Normal B Rinses. Spin Wash at 90°C {button WHITES Nominal B+ premed) Rinses, Spin oy, FAST il * Wash at 60°C ' COLOREDS Normal Rinses.
PROGRAMMED FOR SYNTHETICS, DELICATE AND WOOL Recommended load: max 2.25 kg (5ib); wool max: 1 kg (2.21b) pear COMPARTMENTS programmer PROGRAMMED TO USE DESCRIPTION OF SOIL (oo equipping) DAL POSITION Wash at 50°C H Rinses Stops with water in the drum MIXED FABRICS Normal Wash at 40°C SYNTHETICS/ /il Rinses DELICATE Nomad / J Stops with water in the drum Wash at 40°C K Rinses Stops with water in the drum WOOL Normal Rinses, with fabric L softener, if required.
WHICH DETERGENT ? To ensure you obtain the best wash results from your appliance, it is important 1o use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines. To maintain the appearance of your clothes and household textiles and to make them fast longer you should use different types of detergent for different washes, whether for whites, colors or delicate. Whites We recommend the Ariel product range which is biological and ”.
USING YOUR MACHINE WASHING 4.5 KG OF COLOR FAST COTTON AT 60°C, REGULAR WASH Suppose you have 4.5 kg normally dolled foundry to wash. iris cotton and is color fast at 60°C. 1 Load the laundry Pen the door by pulling the calk outward. Load the items one at a time and close the door. 2 Measure out the detergent Pauli out the detergent dispenser drawer from the control panel.
USING YOUR MACHINE WASHING 2,25 KG OF SYNTHETICS AT 40°C Suppose you have 2.25 kg of synthetic fabric laundry to wash. They are rather delicate fabrics and should not be washed at a high temperature. 1 Load the laundry Open the door by pulling the catch outward. Load the items one at a time and close the door. 2 Measure out the detergent Pull out the detergent dispenser drawer from the contort pane. Measure out the amount of detergent required and pour into the main wash compartment.
MAINTENANCE AND CLEANING Before any maintenance of cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we normally use contains dime. Iris a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help o prevent the formalin of lime deposits. After each wash Leave the door ajar for a while.
SERVICING Before contacting your nearest Gaussian Service Center, please make the following checks: The machine does not start up + The programmer selector dial has not been pulled ou + The door is not closed properly + No water is entering the machine {see: the machine does not diff} The machine does not fill + The water taps are not turned on + The water supply has been disconnected * The inlet hoses are kinked » The water pressure is too low « The water inlet fighters are clogged The machine empties as i
PEACE OF MIND FOR TWELVE MONTHS Gaussian standard guarantee conditions This guarantee is addition to your statutory and other legate rights.