Owner`s manual

20
Connecting Your Equipment
Caution:
Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker
terminal. If any of the bare speaker wire touches the back panel it may cause the power to
cut off as a safety measure. Use good quality speaker wire to connect the speakers to the
receiver.
A and B Speaker Systems
The receiver has two speaker systems: A and B. A is the main system supporting the full
speaker setup. If you switch on both A and B speaker systems, only the front speakers and
the subwoofer will be audible. No sound will come from the center or surround speakers,
but multi-channel sources will be down-mixed to the active speakers so no sound will be
lost. Similarly, if you choose just the B system, you will only hear the front speakers
connected to the B system and multi channel sources will be down-mixed to these two
speakers.
1 Twist exposed wire strands together.
2 Loosen speaker terminal and insert
exposed wire.
3 Tighten terminal.
Speaker Terminals
3/8 in. (10mm)
The speaker terminals also
accept single banana
plugs. (Refer to speaker
manual for details.)