Owner`s manual

22
Connecting Your Equipment
AC Outlet
Power supplied through this outlet is turned on and off by the receiver's POWER switch.
Total electrical power consumption of connected equipment should not exceed 100 W (0.8 A).
Caution:
Do not connect a heater, TV or any other kind of heavy appliance. Also, make sure no
exposed speaker wire is touching the rear panel, as this may cause the receiver to turn
off automatically.
Notes:
• This unit should be disconnected by removing the power plug from the wall socket when
not in regular use.
• Do not connect appliances with high power consumption such as heaters, irons, or
television sets to this AC OUTLET in order to avoid overheating and fire risk. This can
also cause the receiver to malfunction.
Power-Cord Caution
Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never
touch the power cord when your hands are wet, as this could cause a short circuit or an
electric shock. Do not place the unit, a piece of furniture, or anything else heavy on the
power cord, or pinch the cord. Never make a knot in the cord or tie it with other cables. The
power cord should be routed so it is not likely to be stepped on. A damaged power cord can
cause a fire or give you an electrical shock. Check the power cord once in a while. When you
find it damaged, contact your local RadioShack store for assistance.
By connecting an optional control cable, you
can control other equipment with an
OSR
mark using this remote control. Point the
remote control towards the remote sensor of the
receiver, even when operating other equipment.
The remote control signals are received by the
receiver's remote sensor, and sent to the other
devices via the CONTROL OUT terminal.
Note:
You can also control components with an OSR
mark by pointing the receiver's remote control
directly at the component. This type of
operation does not require control cables.
Receiver
Other Products with
OSR Mark
Connect to Control in
Terminal of Other
Products with OSR Mark.
Remote control
unit
CONTROL
OUT
OUT
IN
CONTROL
Operating Other Components