Owner`s manual

7
Supplied Accessories
Please check that you have received the
following supplied accessories:
• AM loop antenna
• FM wire antenna
• Remote control
• Owner’s manual
Placing the Receiver
Please note the following points:
• Do not place objects directly on top of
this unit. This prevents proper heat
dispersal.
• When installing on a rack, shelf, etc., be
sure to leave more than 8 inches (20 cm.)
of space above the receiver.
Avoiding Magnetic
Interference
Make sure not to bend the cables over the
top of this unit (as
shown in the
illustration). If this
happens, the
magnetic field
produced by the
transformers in
this unit may cause a humming noise from
the speakers.
Installing the Batteries
The remote control operates on two AA
batteries (not supplied). We recommend
RadioShack alkaline batteries for longest life.
Introductory Information
Cautions:
Incorrect use of batteries may result in such
hazards as leakage and bursting. Observe
the following precautions:
• Never use new and old batteries together.
• Insert the plus and minus sides of the
batteries properly according to the marks
in the battery case.
• Batteries with the same shape may have
different voltages. Do not use different
batteries together.
• When disposing of used batteries, please
comply with governmental regulations or
environmental rules that apply in your
country or area.
Operating the Remote
Control
The remote control may not work properly
if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that
is emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control
unit.
30
30
23ft (7m)