Owner`s manual
9
5 Minute Guide
Listening to Surround Sound
This receiver was designed with the easiest possible setup in mind, so with the following
quick setup guide, you should have your system connected for surround sound in no time at
all. In most cases, you can simply use the receiver’s default settings.
1 Connect your DVD player.
For surround sound, you need to make a digital connection from the DVD player to the
receiver. You can do this with either a coaxial, or an optical connection (you do not need to
do both). If you connect using an optical cable, you should refer to “Optical Digital Input
Setting” on page 38 to assign the optical input to DVD.
Use a video cable to connect the video output on your DVD to the receiver using the jacks
shown below.
2 Connect the receiver to your TV.
Use a video cable to connect your receiver to the TV using the jacks as shown below.
ASSIGNABLE
A
B
MONITOR
OUT
MONITOR OUT
FRONT
RL R LRL
FRONTCENTE R SURROUND
S
P
E
A
K
E
R
S
YP
B
P
R
YP
B
P
R
OUT
IN
IN
IN
S - VIDEO
VCR /
DVR
TV/
SAT
DVD/
LD
CONTROL
PREOUT
CENTER
OUT
ANTENNA
AM
LOOP
FM
UNBAL
75
Ω
R
AUDIO
L
DVD 5.1CH INPUT
IN
IN
IN
IN
IN
IN
IN
IN
IN
RL
CENTER
SURROUND
SUB W .
CD
AUX
VCR /
DVR
TV /
SAT
DVD
/LD
PLAY
CD-R
/TAPE
/MD
FRONT
PREOUT
COAX OPT OPT
COMPONENT
VIDEO
(
DVD/ LD
)(
CD
)
(
TV / SAT
)
OUT
MONITOR
OUT
SUB W.
VIDEO
REC
¥¥ø
ø
ASSIGNABLE
DIGITAL I N
DIGITAL
OUT
(
T V / SAT
)
IN
D V D
5.1CH
INPUT
(
DVD/ LD
)
IN
¥
S
IN
OUT
MONITOR
OUT
SUB.W
PREOUT
COAX
OPT
(
DVD/LD
)
(
TV/SAT
)
¥
¥
ASSIGNABLE
DIGITAL IN
VIDEO
Optical cable
DVD player
TV
DIGITAL OUT VIDEO OUT
VIDEO IN
Coaxial cable
Video cable
This receiver
Video cable
Note: If you connect
using a optical cable,
see "Optical Digital
Input Setting" on
page 38 to assign the
optical input to DVD.
IN
IN
FRONT
DVD
/LD
CD-R
REC
/TAPE
/MD
D V D
5.1CH
INPUT