LAVADORA WASHING MACHINE FLS 1276 124971380 INSTRUCCIONES PARA INSTALACION Y USO INSTALLATION AND INSTRUCTION MANUAL E GB
Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
Contents Disposal Maintenance 24-25 Bodywork 25 Tips for environmental protection 25 Technical specifications 26 Installation 27 Unpacking 27 Positioning 27 Water inlet 27 Water drainage 28 Electrical connection 28 Your new washing machine 29 Description of the appliance 29 Detergent dispenser drawer Use 30 Control panel 30 Controls 30 Washing hints 31 Sorting the laundry 31 Temperatures 31 Before loading the laundry 31 Maximum loads 31 Laundry weights 31 Removing
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door seal and prevents the formation of musty smells. • All internal packing must be removed before using the appliance.
Child safety • Keep all detergents in a safe place out of children’s reach. • Children are often not aware of how dangerous electrical appliances can be. When the machine is working, children should be carefully supervised and not be allowed to play with the appliance. • When the appliance is to be scrapped, cut off the electrical supply cable and destroy the plug with the remaining cable. Disable the door catch in order to prevent children from becoming trapped inside while playing.
Technical specifications DIMENSIONS Height Width Depth 85 cm 60 cm 54 cm MAXIMUM LOAD Cotton Synthetics Delicates Woollens 4.5 kg 2 kg 2 kg 1 kg SPIN SPEED 1200 rpm max. POWER SUPPLY VOLTAGE/FREQUENCY TOTAL POWER ABSORBED MINIMUM FUSE PROTECTION 220-230 V/50 Hz 2200 W 10 A WATER PRESSURE 5 N/cm2 80 N/cm2 Minimum Maximum This appliance complies with the following EEC Directives: 73/23/EEC of 19/02/73 relating to low voltage 89/336/EEC of 03/05/89 relating to electromagnetic compatibility.
Installation Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. All transit bolts and packing must be removed before using the appliance.
Water drainage Electrical connection The end of the drain hose can be positioned in three ways: This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply. Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall.
Your new washing machine This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. • The temperature selector dial will allow you to choose the most suitable temperature for your laundry. • The automatic cooling of the washing water from 90° to 60°C before draining will prevent old drain pipes from being deformed. • The balance control device ensures the machine is stable during the spin.
Use Control panel BIO Temp. Temp. Blancos con prelav. Blancos sin prelav. Colores resistentes Colores delicados Sintéticos con prelav. Sintéticos sin prelav.
Laundry weights Washing hints The following weights are indicative: Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. Temperatures 90° 60° for normally soiled white cottons and linen (e.g. tea cloths, towels, tablecloths, sheets...) for normally soiled, colour fast garments (e.g. shirts, night dresses, pyjamas....
Quantity of detergent to be used Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk.
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. 95 60 40 30 Max. wash temperature 95°C Max. wash temperature 60°C Max. wash temperature 40°C Max.
4. Select the temperature Operating sequence Turn the dial to the required setting. Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine. 90° 1. Place the laundry in the drum P0450 Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible.
7. At the end of the programme The machine stops automatically. ENGLISH If you have selected a programme which ends with the water of the last rinse left in the tub (option ), drain the water before opening the door. Select programme “Q” (drain) or depress again button . Wait one or two minutes before opening the door to give the electric locking mechanism time to release it. Depress the START/STOP button to switch the machine off. The operating pilot light goes out. Remove the laundry.
Programme table Washing programmes for cotton and linen Consumptions* Programme A Temp. 60°-90° Fabrics Additional functions WHITES WITH PREWASH, for example work garments, sheets, household linen, underwear, towels Max. load Energy kWh Water lt Duration min. 4.5 kg 2.4 68 155 4.5 kg 2.1 55 140 4.5 kg 1.0 52 130 4.5 kg 0.85 72 70 4.5 kg 0.
Programme table Washing programmes for synthetics, mixed fabrics, delicates and wool Consumptions* H J Temp. 30°-60° Fabrics SYNTHETICS WITH PREWASH, underwear, coloured items, shirts, blouses Max. load Energy kWh Water lt Duration min. 2 kg 1.2 59 110 2 kg 1.0 49 90 2 kg 0.
Maintenance 1. Bodywork 3. Drain filter Clean the outside of the machine with warm water and a neutral, non-abrasive household detergent. Rinse with clean water and dry with a soft cloth. The drain filter collects threads and small objects inadvertently left in the laundry. Check regularly that the filter is clean. Important: do not use methylated spirits, solvents or similar products to clean the bodywork. Place a container under the filter and unscrew it. 2.
5. Emergency emptying out If the water is not discharged (outlet pump is blocked, filter or drain hose are clogged), proceed as follows to empty out the machine: ENGLISH • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the water has cooled down; • place a bowl on the floor; • put the drain hose end into the bowl and let the water come out.
Something not working? Problems which you can resolve yourself. Problem Possible cause • The machine does not start up: • The door is not firmly closed. • The machine is not plugged in or there is no power at the socket. • The main fuse has blown. • The programme selector dial is not positioned correctly and the START/STOP button is not pressed. • The water tap is closed. • The machine does not fill: • The inlet hose is squashed or kinked. • The filter in the inlet hose is blocked.
Possible cause • Spinning starts late or the machine does not spin: • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Z
