CONTENTS Instructions for the user Instructions for the installer Warnings 27 Safety 43 Description of the appliance 29 Technical Features 44 Use of the appliance 30 Installation 45 Advice for use 38 Specification nozzles 48 Maintenance and clening 39 Oven lamp remplacement 49 What to do if the appliance does not 41 work Guarantee conditions 42 After Sales Service 42 How to read the instruction book ? The symbols bellow will guide you when reading the instruction book Safety instru
WARNINGS It is very important that this instruction book should be kept safety for future consultation. If it should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know the functions of the machine and also be aware of the warnings. This warnings has been given for your and others safety. • This appliance has been designed for use by adults. Take care therefore, that children do not attempt to play with it.
• Do not leave anything (cloths, aluminium foil, etc.
DESCRIPTION OF THE APPLIANCE Control panel 1 ZANUSSI TOP TOP OVEN OVEN GAS GAS 1 2 3 2 1. 2. 3. 4. 5. TIMER 110 4 5 6 30 3 80 7 40 70 4 GAS 20 90 8 GAS GAS 10 100 5 60 6 50 7 8 9 10 6. Timer knob 7. Middle burner control knob 8. Front right burner control knob 9. Back right burner control knob 10. Ignition switch Oven light switch Turn spit switch Oven/grill knob Back left burner control knob Front left burner control knob Hob 2 3 1 4 5 1.
USE OF APPLIANCE 1. GAS OVEN Before the first use ensure that the room is well ventilated: V.M.C. (Mechanic ventilation) or opened window. How to proceed ? 1. Lift the lid 2. Remove the oven accessories 3. Detach the adhesive labels, the foil protection if there is 4. The oven burner hase a safety tap. In case the flame dies out the safety tap stops the gas supply. Clean the accessorie(s) with detergent. Rinse and dry carefully. a soft During cooking in the oven the oven door is hot.
The oven can be used for traditional cooking, or for grilling, but not both functions simultaneously. The symbol on the knob corresponds to the symbol on the control panel. “8” “1” Off Maximum Minimum Grill function (heat come from the top burner only. OVEN Ignition 1. Open the oven door. 2. Lift the small lid on the bottom of the cavity, push and turn the control knob to the left to position 8 (fig.1), maintain it pressed even after bringing near the flame (fig.2)., 3.
Extinguishing of oven burner Turn the knob clockwise to mark « safety device is in place. • ». The Grill When using the grill it has to be supervised, the oven door opened the protective screen “A” in its place. A Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon …) that remains tender, for toast or to brown already cooked. Grill burner ignition 1. Open the oven door assemle the protective screen “A” in its place (fig.3). 2.
Extinguishing of grill burner Turn the knob clockwise to mark « safety device is in place. • ». The Grilling 1. Preheat the oven for 5 or 10 min. on position grill. 2. Insert the food and the oven grate on the oven. 3. Insert the roasting tray under the oven grate. 4. Adjust the oven grate and the roasting tray to allow for different thicknesses of food. 5. When the first side is brown, turn the meat without pricking it in order that the juices are not lost. 6. Grill the second side.
Turn-spit The external parts of the cooker are hot when using the turn-spit. Do not allow children near it. During cooking the oven will be opened and the protective screen “A” in place the spit and its support are hot after cooking. Use gloves. 1. 2. 3. 4. 5. 6. 7. 8. How to use the turn-spit ? Open the oven door and fix the protective screen “A” (fig. 5). Place correctly the meat on the spit trying to balance the weight for avoiding useless effort for the motor. Fix the second fork. Block the two forks.
Light in the oven The oven is equipped with a lamp to allow of meals during cooking. It starts operating when the knob on the control panel is pressed (fig. 8) Mechanical timer Turn the regulation knob (fig. 9) clockwise to maximum position and than turn it back to the position corresponding to the period of time necessary for the cooking. At the end of the time selected an acoustic signal intervenes which stops automatically.
Do not close the cover till the plate is hot, the cover could be damaged. Ignition of the burners 1. Push the knob and turn it left to the symbol “big flame”. 2. In the same time, push the electronic ignition knob (fig. 11) for obtaining sparkles. Keep it pushed till turning up of the flame (1 spark / second). OR Approach a flame to the burner after turning the corresponding knob (lack of power). 3. Adjust the flame on desired position. fig.
3. Accessories delivered with the appliance Beside the accessories delivered with the appliance we advise you to use only heat proof pots (according to the instructions of the manufacturer). Your cooker is equipped with: • a grate, pan support for putting the dishes on (roast, pastry moulds …) The dish has to be put in the middle of the grate to balance the weight. • a roasting tray. It is used to collect juice when cooking in it, place it on the shelf 2.
ADVICE FOR USE Oven cooking • Turn off your oven 5 minutes before the foreseen cooking time you will save power, the accumulated heat will allow to end cooking; • The thickness, the conductibility and the color of pot influences the culinary results; • When cooking, certain dishes increase in volume, choose the pot so that above the raw mixture remain enough place; • For preventing fat dripping when roasting use tall rim pans proportional to the piece to be roasted; • Prick the skin of poultry and the sausa
MAINTENANCE AND CLEANING Before cleaning, check that the knobs are on “off” position, that the appliance has cooled completely and that it is disconnected. Never use abrasive powder or wire sponge for cleaning the appliance. Burners Clean the covers with warm water and mild detergent, remove all crust. Never use vinegar. The flame splitters have to be kept clean for ensuring good ignition. Before igniting make sure the flame splitter and the caps are properly replaced. The assembly has to be perfectly dry.
Oven Enamelled parts: Same cleaning as other enamelled parts. Oven door cleaning For a complete cleaning of the oven door it is advisable to dismantle as follows: -open the door completely (fig. 13) -turn the two blocking parts on the hinges arms 60º. fig. 13 -close partially the door, to a 30º angle (fig.14). -lift the door and pull it out. fig. 14 The internal oven door glass can be removed for cleaning. For this purpose draw out the 2 fixing screws (fig.15).
WHAT TO DO IF THE APPLIANCE DOES NOT WORK If the appliance does not work properly, check the following points before asking for service; there could be simple problems that you could remedy by yourself; if not, contact your after sales service. Symptoms Solutions No burner ignites Check that: • gas supply is completely open; • the position of gas pipe is right; • the gas cylinder or the tank is not empty. The burner do not ignite Check that: • the burner is in its right place; • the burner is not wet.
GUARANTEE CONDITIONS Guarantee stipulated in the contract 1 year starting from setting into function the manufacturer will replace the damaged parts except the cases mentioned in chapter “Reserves”. Conditions for applying For applying this guarantee you have to direct to the distributor who sold you the appliance and submit to him your Guarantee Certificate. The dealer will or will not overtake the expenses for the labor and transport in accordance with their sales conditions.
INSTRUCTIONS FOR THE INSTALLER ADVICE FOR SAFETY • • • • • • Before installation ensure that the local distribution conditions (gas nature and pressure) and the pre-setting of the appliance are consistent; This appliance must be installed only in a room with good ventilation; The adjusting conditions of this appliance are mentioned on the rating plate; This appliance is not connected to a flue gas exhaust device. It has to be installed and connected in accordance with the rules in force.
TECHNICAL FEATURES Free standing Hob Classe 1 Cover Pan support Front right Back right Front left Back left Middle (fish) Oven Oven Over burner power Grill Grill burner power Light in the oven Accessories Oven grid Roasting tray Protective screen Turn-spit Dimensions Height Breadth Depth This appliance complies with the following EEC Directives : 90/683 ; 73/23 (Low Voltage Directive) and subsequent modifications, 89/336 (Electromagnetical Compatibility Directive) and subsequent modifications, 90/39
INSTALLATION Placement Remove the plastic packaging and install the cooker in a dry, ventilated room (fig. 16) not near curtains, paper, alcohol, petrol, etc…) The appliance has to be set on a heatproof soil. This appliance belongs to class “1” in matters of protection against overheating of surrounding surfaces. It is mandatory to keep 2 cm distance to the furniture walls. The furniture cannot be taller then the cooker hot plate.
Gas connection Your cooker is delivered adjusted for the kind of gas stated on the rating plate. It might be necessary to pass to another kind of gas, different to the one it is preset to. Under these circumstances follow the instructions bellow. For best efficiency, lowest consumption and a longer length of life of your cooker, the manifold gas pressure has to respect the values shown in table no.
Fuse capacity: 16A Note: Check on the rating plate the value for the total connection power for establishing the fuse power. In case of a direct connection to the mains you have to interpose an omnipolar switch a minimum opening between contacts of 3 mm. The yellow-green grounding cable has not to be interrupted by the switch. The supply cord must be positioned in such a way as it does not reach in any point a temperature higher by 50˚C than the room temperature.
Bottle installation • • • The length of the flexible pipe has to be 1m. The connection of the regulator has to be fronted to the righr of the appliance. It is MANDATORY to fix the pipe at the back of the appliance, by means of a collar (fig. 17).
OVEN LAMP REPLACEMENT Before replacing the lamp take care that all control knobs be on “off” position « ». Disconnect the appliance; watch that the oven be cool. This lamp of 15 W, convection E 14 (230/240V) is a special lamp for “higher” temperature, up to 300˚C. It is supplied on order, by your After Sales Service. The lamp is fixed in front of the oven and is accessible from inside. For reaching the lamp: 1. Unscrew the glass lamp protection (fig. 18); 2. Unscrew the lamp; 3. Replace the lamp; 4.
