Operation Manual

Starting a programme without the Klaar
Over/Fini Dans option
Touch the button .
• The indicator of the button stops to
flash and stays on.
• The programme starts, the lid locks, the
indicator is on.
• The drain pump can operate for a short
time at the beginning of the washing
cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts
automatically the programme
duration agree with the laundry
load.
• The display shows the new value.
Starting a programme with the Klaar
Over/Fini Dans option
1. Touch the button again and again to
choose the number of hours in which you
want the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
is on to show that his option is active.
2. Touch the button :
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Klaar Over/Fini Dans option
before you touch the button .
After touching the button you
can only cancel the Klaar Over/Fini
Dans option.
To cancel the the Klaar Over/Fini Dans option:
a. Touch the button to set the
appliance to pause. The indicator of
button flashes.
b. Touch the button until the indicator
above this button goes off.
Touch the button again to start the
programme immediately.
When using liquid detergents in
combination with the Klaar Over/Fini
Dans option, add the liquid
detergents with a dosing ball
(supplied by the detergent's
manufacturer).
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any
option the Klaar Over/Fini Dans option (if
set) will be disabled.
3. Touch again.
The programme continues.
Cancelling a programme
1. Press the button for some seconds to
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
The appliance does not drain the
water. The water left in a drum can
be used for the next washing cycle.
Opening the lid
While a programme (or the ) operates, the
appliance lid is locked. The indicator is on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the lid.
To open the lid during the first minutes of
the cycle (or when the operates) :
1. Touch the button to pause the
appliance.
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
again. The programme (or the )
continues.
11