User manual

8
Operation
Hob burner control knobs
The symbols on the knobs mean:
= no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
Lighting the burners
To light a burner:
1. press the ignition pushbutton which is
marked with a little spark ,
2. then push down the relevant control knob
and turn it anticlockwise to maximum posi-
tion.
Do not keep the control knob
pressed for more than 15 seconds.
If the burner does not light even
after 15 seconds, release the control
knob, turn it the "off" position and
wait for at least one minute before
trying to light the burner again.
After lighting the flame, keep the knob
pushed down for about 5 seconds. This will
allow the "thermocouple" (Figs. letter D) to be
heated and the safety device to be switched off,
otherwise the gas supply would be interrupted.
Then, check the flame is regular and adjust it
as required.
)
When the hob is first installed
Once the hob has been installed, it is
important to remove any protective
materials, which were put on in the
factory.
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple