User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
• • • • • • • • • • • • • • The appliance can be installed as freestanding or below the kitchen counter with correct space (Refer to the Installation leaflet). Do not install the appliance behind a lockable door, a sliding door or a door with a hinge on the opposite side, where the appliance door can not be fully opened. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. Connect the mains plug to the mains socket only at the end of the installation.
• • • • • Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. Remove all objects from pockets such as lighters and matches. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged.
• • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. DISPOSAL WARNING! Risk of injury or suffocation. • • • Disconnect the appliance from the mains supply. Cut off the mains cable and discard it. Remove the door catch to prevent children and pets to get closed in the appliance.
EASY START PRODUCT DESCRIPTION 5 1 2 3 6 4 7 1 Space for programme chart (Self-adhesive label) 2 Door Latch (push the knob to the right to open): Avoid opening the door while a program is in progress. 3 Control panel 10 Space for programme chart (Self-adhesive label) 11 Adjustable feet: If the dryer is not being wall mounted the feet need to be adjusted so that the dryer is level.
8 15 9 14 10 11 13 12 CONTROL PANEL 1 2 1 2 3 Start button - After selecting the programme and drying time, press this button to start the dryer. Drying indicator - Lit during drying stage. 3 Water tank indicator - Lit when water tank is full. 4 Timer knob - This knob is used to set both the drying time and the drying temperature required. Separate time scales and temperatures for Cotton (max 120 min) and Synthetics (max 80 min).
• is used to represent cotton. Here you can set the dryer for up to 120 minutes, because cotton and thick non-synthetic fabrics need longer to dry. • is used to represent synthetic fabrics and delicate items. Because these are more sensitive than cotton, they need a lower drying temperature. Here you can set the dryer for up to 80 minutes. Programmes Do not overdry your laundry. It can make it difficult to iron, and harsher to the touch, besides wasting energy.
3. Check that the fluff filter is clean and that the coarse filter is lowered and has snapped into place. 4. Check that the water tank is empty and pushed correctly into place. 5. Put the load for drying into the machine. Make sure that it is right inside the drum. Do not mix synthetics with natural materials. 6. Close the door. 7. According to the type of load, turn the timer knob to a suitable drying time on either the Cotton or the Synthetics time scale. 8. Press the start button inwards.
To clean them: 1 2 3 1 Open the door. 2 Open the coarse filter upwards 3 Brush the fluff off the fluff filter, which is under the coarse filter. Sometimes you may need to remove the fluff filter to clean it on both sides. Make sure that you put the fluff filter back correctly after cleaning, before closing the coarse filter. DRAINING THE WATER CONTAINER If you have connected the tumble dryer directly to a waste pipe with the accessory hose, you can ignore this section.
To clean the condenser: 1 2 3 4 6 7 8 1 Open the door. 2 Open the coarse filter upwards. Remove the fluff filter and close the coarse filter again. 3 Grasp the recesses at the top of the condenser with your fingers and use your thumbs to press against the door. 4 The condenser will come free, allowing you to lift it outwards/upwards. Be careful not to damage the sensitive aluminium section 5 Turn it upside down and clean it on both sides, using a vacuum cleaner.
TROUBLESHOOTING Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If service is called to resolve a problem Fault The dryer will not start. listed below or to repair a fault caused by incorrect installation or mis-use, there is a risk that you will be responsible for the cost.
INSTALLATION POSITIONING You can install this dryer in a number of different ways. We will show you the most suitable of these. Whichever way you install it, here are some points to bear in mind: • Always ensure that the dryer is level for optimum functioning. • The temperature in the room should not exceed +35° C when the dryer is operating. If it does, open a door or window while the dryer is on. The dryer uses the air in the room for cooling. • The area around the dryer should be as dustfree as possible.
3. 4. 5. 20-30° TECHNICAL DATA 14 Height x Width x Depth 686 x 605 x 420 mm (maximal 460 mm) Max. depth with the appliance door open 900 mm Max.
Voltage 230 V Frequency 50 Hz Necessary fuse 10 A Total power 2000 W Energy efficiency class C Energy consumption1) 2,93 kWh Annual energy consumption2) 358 kWh Left—on mode power absorption 0W Off mode power absorption 0W Type of use Household Permitted ambient temperature + 5°C to + 35°C Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 1) With reference
136904063-A-482014 WWW.ZANUSSI.