EN User Manual Fridge Freezer ZBB28442SA
Contents Safety information Safety instructions Operation Daily Use Hints and tips 2 3 4 5 6 Care and cleaning Troubleshooting Technical information Installation 7 8 10 10 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • • • • • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
Use Care and cleaning WARNING! WARNING! Risk of injury, burns, electrical shock or fire. • • • • • • • • • • • • Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
1. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. 2. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. CAUTION! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
compartment let the appliance run at least 2 hours on the higher settings. WARNING! In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then refrozen (after cooling). Ice-cube production Do not use metallic instruments to remove the trays from the freezer. 1. Fill these trays with water 2.
• • • • • make it possible subsequently to thaw only the quantity required; wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; lean foods store better and longer than fatty ones; salt reduces the storage life of food; water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt
Defrosting the freezer CAUTION! Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. About 12 hours prior to defrosting, set a lower temperature, in order to build up sufficient chill reserve for the interruption in operation.
Problem The appliance is noisy. Possible cause The appliance is not supported properly. The compressor operates contin- Temperature is set incorrectly. ually. Water flows inside the refrigerator. The temperature in the appliance is too low/too high. Solution Check if the appliance stands stable. Refer to "Operation" chapter. Many food products were put in at the same time. Wait some hours and then check the temperature again. The room temperature is too high.
3. Reassemble the lamp cover. 4. Connect the plug to the mains socket. 5. Open the door. Make sure that the light comes on. 1 2 Closing the door 1 2. Replace the lamp with one of the same power and shape, specifically designed for household appliances. (the maximum power is shown on the light bulb cover). 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre.
Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre.
Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket. In case you do not want to carry out the above mentioned operations, contact the nearest Authorised Service Centre.
C Ha D E E Hc B 10. Install the vent grille (B). 11. Attach the hinge covers (E) to the hinge. 12. Connect the appliance laterally to the kitchen furniture sidewall: a. Loosen the screws of the part (G) and move the part (G) till the furniture sidewall. b. Tighten the screws of the part (G) again. c. Attach the part (H) to the part (G). 14. Open the appliance door and the kitchen furniture door at an angle of 90°. a. Insert the small square (Hb) into guide (Ha). 8 mm Hb GH Ha b.
If the ambient temperature is low (for example, in winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases. Hb Hd Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet. ENVIRONMENT CONCERNS appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle the materials with the symbol .
www.zanussi.
222371175-A-472014 www.zanussi.
