EN User manual Fridge-Freezer ZBB6244
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 5 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Environmental concerns _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Subject to change
squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. • This appliance is heavy. Care should be taken when moving it.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rub- Switching on Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Temperature regulation The temperature is automatically regulated.
1. Activate the Ambient Switch function at least 24 hours before placing food. 2. Place the food on the bottom drawer of the freezer compartment. 3. After 24 hours, when the freezing process is completed, deactivate the Ambient Switch function. Warning! The freezing process takes some hours: during this period do not add other food to be frozen. Important! The maximum amount of food that can be frozen in 24 hours is specified on the rating plate, a label located on the inside of the appliance.
• position food so that air can circulate freely around it Hints for refrigeration Useful hints: Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the most. Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided.
Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use.
Important! There are some sounds during normal use (compressor, refrigerant circulation). Problem The appliance does not operate. The lamp does not operate. Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is Connect a different electrical appliance no voltage in the mains socket. to the mains socket.
Replacing the lamp Caution! Disconnect the plug from the mains socket. 1. Remove the screw from the lamp cover. 2. Remove the lamp cover (refer to the illustration). 3. Replace the used lamp with a new lamp of the same 4. 5. 6. 7. power and specifically designed for household appliances (the maximum power is shown on the lamp cover). Install the lamp cover. Tighten the screw to the lamp cover. Connect the plug to the mains socket. Open the door. Make sure that the light comes on. Closing the door 1.
1 2 3 4 5 Important! The wires in the mains lead are coloured in accordance with the following code: 1 Green and Yellow: Earth 3 Brown: Live 5 Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: • Loosen the upper pin and remove the spacer. • Remove the upper pin and the upper door. 10 • Loosen the middle hinge. 1.
Ventilation requirements The airflow behind the appliance must be sufficient. Installing the appliance 50 mm Caution! Make sure that the mains cable can move freely. min. 200 cm2 Do the following steps: min. 200 cm2 2 I 4mm 1 44mm I Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm.
ca. 50 mm Ha D C Hb 21 mm E E Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. Ha B 90° Hc Hd ca. 50 mm 21 mm Attach the covers (C, D) to Disconnect the parts (Ha), the lugs and the hinge (Hb), (Hc) and (Hd). holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. Ha K Ha Hb Push the part (Hc) on the part (Ha). Install the part (Ha) on the inner side of the kitchen furniture.
Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
222324877-00-052010 www.zanussi.