User manual

PR266

Separate parts Ha, Hb, Hc, Hd as shown in the

figure

D724

Press in the joint covers between the appliance and

the kitchen unit.

Fasten the appliance with 4 screws provided in the

kit included with the appliance.

Apply covers (C-D) on joint cover lugs and into hinge

holes.

Snap vent grille (B) and hinge covers (E) into

position.

From the plastic cover (E), which is used to cover the

hinge with the pivot pin, you must take away the part

as indicated in the drawing.

This operation is made easer since there is, in the

internal part of the cover hinge lid a groove that

facilates the removal of this coomponent.

“Remove the part marked with DX, if the pivot pin is

inserted in the right hinge, SX in opposite case.”