User manual

INSTALLATION
WARNING! Refer to Safety chapters.
TECHNICAL DATA
Dimensions
Height 899 - 917 mm
Width 550 mm
Depth 600 mm
LOCATION OF THE APPLIANCE
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
For the minimal distances of fitting check the table.
A
E
C
B
D
F
Minimum distances
Dimension mm
A 650
B 150
C 2
D 400
E 450
F less than 400
LEVELLING OF THE APPLIANCE
Use small feet on the bottom of appliance to set the
appliance top surface level with other surfaces.
THE STABILITY CHAIN
CAUTION! Install the stability chain to
prevent the appliance from tilting. The
stability chain only works when the
appliance is put in a correct area.
1. Measure down 180 mm from the appliance top
surface, then measure right 30 mm.
2. Mark the position of the wall and this gives
anchor point for the stability chain.
30 mm
180 mm
OTHER TECHNICAL DATA
WARNING! These instructions are
only valid in the countries whose
symbols appear on this booklet's
cover.
Gas category: I2H
Gas supply: G20 (2H) 20 mbar
Voltage: 220-240 V
Frequency: 50/60 Hz
21