User manual

Problem Possible cause Remedy
The flame is blow out immediately
after ignition.
Thermocouple is not heated suffi-
cient.
After lightning the flame, keep the
knob pushed for approximately 5
seconds.
The gas ring burns unevenly. The burner crown is blocked with
food residue.
Make sure that the injector is not
blocked and the burner crown is
clear of food particles or cleaning
fluids. Dry them with a cloth and
clean stubborn marks away with a
dry nylon brush (for example an
old toothbrush).
The oven does not heat up. The oven is not switched on. Switch on the oven.
The oven does not heat up. The necessary settings are not
set.
Control the settings.
The oven does not cook evenly. Check that the appliance is cor-
rectly installed and levelled, and
that you use the recommended
temperatures and shelf positions.
The oven lamp does not operate. The oven lamp is defective. Replace the oven lamp.
Steam and condensation settle on
the food and in the oven cavity.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15-20 mi-
nutes after the cooking process
ends.
The appliance makes noises or
popping sounds.
When the gas is drawn through
the burner, it can compress as
they heat up. Some metal parts of
the appliance expand and contract
when they heat up or cool down.
The noises are normal.
The flame colour is orange or yel-
low.
The flame can look orange or yel-
low (flame disturbance) in some
areas of the burner because of
how the burner is made. This is
normal.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
18
www.zanussi.com