User manual

Problem Possible cause Remedy
comes on the hob display.
There is no cookware on the
zone.
Put cookware on the zone.
comes on the hob display.
The cookware is incorrect. Use the correct cookware.
Refer to "Hob - Hints and tips"
chapter.
comes on the hob display.
The diameter of the bottom of the
cookware is too small for the
zone.
Use cookware with correct di-
mensions.
Refer to "Hob - Hints and tips"
chapter.
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The necessary settings are not
set.
Make sure that the settings are
correct.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Installation
WARNING!
Refer to Safety chapters.
Technical data
Dimensions
Height 894 - 912 mm
Width 600 mm
Dimensions
Depth 600 mm
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
www.zanussi.com 25