User manual

18
Installation
Positioning
• Place the refrigerator away from direct sunlight and
heat sources.
• Maintain recommended ventilation - see Fig. 1.
• In the documentation bag you will find two spacers
that must be mounted as shown in the figure in the
back of your appliance.
Please loosen the screw under its head and then unlo-
osen again.
• Make sure the refrigerator is accurately levelled tur-
ning the adjustable feet in order to avoid vibrations
and noises Fig. 2.
• This is a built in design to be aligned with other furni-
ture.
•
The appliance should be only set up at a location
whose ambient temperature corresponds to the clima-
Fig. 2
Fig. 1
te classification, for which the appliance is desig-
ned.
• The climate classification can be found on the
serial plate of the appliance.
• The following table shows which ambient tempe-
rature is correct for each climate classification:
Climate classification for an ambient temperature of
SN + 10 to + 32°C
N + 16 to + 32°C
ST + 18 to + 38°C
T + 18 to + 43°C
• The manufacturer make sure the correct operation
of the appliance from minimum temperature of
10°C to upper limit of each climatic class.
There is an optional KIT useful when the
ambient temperature is under 10ºC. If you want
it please call to the Spare Parts service, phone:
902116388
Cleaning the interior
• Do not use alcohol or any cleanig product contai-
ning alcohol because it can damage the cabinet.
• Before using the appliance for the first time wash
the interior whith luke warm water and some neu-
tral soap so as to remove the typical smell of a
brand-new product and then dry thoroughly.
• Do not use detergents or abrasive powders as these
will damage the finish.
• Remove security used for transportation.
Electrical connection
mBefore plugging the appliance into a socket make
sure that the voltage and frequency shown on the
rating plate correspond to your home supply.
mIt is essential that the appliance be connected to an
efficient earth tap.
For this purpose the supply cable plug incorporates
a special earth contact. If the sockets of your
domestic wiring system are not grounded, have the
appliance connected to a separate ground wire in
accordance with existing safety regulations.
«THE MANUFACTURER DECLINES TO
ACCEPT ANY LIABILITY IF THIS SAFETY
RULE IS NOT OBSERVED».
Starting – up
• Plug the appliance into the mains.
• Turn to intermediate position the knobs of the
«temperature regulators» «A» Fig. 5.
• Make sure the inner light «H» turns on when ope-
ning de door.
D594