User manual

Warning! Before You place the filter,
please check it there is nothing inside the
filter seat.
4. The filter can be positioned only to one
side. If position is wrong, the filter over-
hangs.
If the filter will not snap into place, the
loading door cannot be closed.
Warning! You must DISCONNECT the
appliance from the electricity supply,
before you can carry out any cleaning or
maintenance work.
Cleaning the door
Clean periodically the interior part of the door to
remove any fluff. Accurate cleaning ensures cor-
rect drying.
To clean the drum
Caution! Do not use abrasive materials to
clean the drum. Use a soft detergent to
clean the inner side of the drum and the drum
blades.
Keep the inner surface of the drum and the
drum blades clean. The minerals from the
water or cleaning agents can collect on the in-
ner surface of the drum. This cause that the
laundry is not sufficient dry.
Clean operating screen and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
appliance.
Use a damp cloth to wipe down the operating
screen and housing.
What to do if ...
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Loading door is open. Close loading door.
Have you pressed the START
PAUSE button?
Press the START PAUSE button
again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme the
next time you dry (see “Programme
chart” chapter).
Fluff filter clogged. Clean fluff filter.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots covered up. Uncover ventilation slots.
Residue on inside surface of drum
or drum ribs.
Clean inside surface of drum and
drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
1)
Re-programme standard setting
for degree of drying (see ‘Machine
settings’ chapter)
1)
.
Loading door does not close.
Filter not in place
2)
. Install filter into place
2)
.
Drying cycle ends shortly after pro-
gramme starts.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Select time programme or higher
drying level (e.g. EXTRA DRY in-
stead of CUPBOARD DRY ).
Drying cycle lasts an unusually
long time. Note: After around 5
Filter clogged. Clean filter.
10
www.zanussi.com