Operation Manual

Alarm code Problem
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 3 times intermittently.
The anti-flood device is on.
Warning! Deactivate the appliance before
you do the check.
Problem Possible cause Possible solution
The programme does not
start.
The mains plug is not connected in
the mains socket.
Connect the mains plug.
The appliance door is open. Close the appliance door.
The fuse in the fuse box is damaged. Replace the fuse.
The delay start is set. Cancel the delay start or wait for the
end of the countdown.
The appliance does not fill
with water.
The water tap is closed. Open the water tap.
The water pressure is too low. Contact your local water authority.
The water tap is clogged or there is
limescale on it.
Clean the water tap.
The filter in the water inlet hose is
clogged.
Clean the filter.
The water inlet hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
The anti-flood device is on. There are
water leakages in the appliance.
Close the water tap and contact the
Service.
The appliance does not
drain the water.
The sink spigot is clogged. Clean the sink spigot.
The water drain hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The filters are clogged. Clean the filters.
The filters are not correctly assem-
bled and installed.
Make sure that the filters are correctly
assembled and installed.
The spray arms are clogged. Remove remaining soil with a thin
pointed object.
The programme was not applicable
for the type of load and soil.
Make sure that the programme is ap-
plicable for the type of load and soil.
25
www.zanussi.com