User manual

ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME

By default this acoustic signal is deactivated but it is possible to activate it.

1. While the appliance is in user mode, within about 5 seconds press programme button twice: the

indicator starts to flash.

2. Wait until the indicators and go off. The indicator is off. The acoustic signal is off.

3. Press programme button to change the setting. The indicator is on. The acoustic signal is on.

4. Press on/off button to confirm the setting.

BEFORE FIRST USE

1. Make sure that the current level of the

water softener agrees with the hardness

of the water supply. If not, adjust the level

of the water softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any processing

residuals that can still be inside the appliance.

Do not use detergent and do not load the

baskets.

When you start a programme, the appliance can

take up to 5 minutes to recharge the resin in the

water softener. It seems that the appliance is not

working. The washing phase starts only after this

procedure is completed. The procedure will be

repeated periodically.

ADDING SALT

Before first use put one litre of water in the salt container.

Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after

you fill the salt container, start a programme.