User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down. Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance.
WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately close the water tap and disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. USE • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. • Do not drink and play with the water in the appliance. • Do not remove the dishes from the appliance until the programme is complete.
EASY START 1 1 On/off button 2 Programme buttons 2 3 4 4 Indicators 3 Delay button INDICATORS Indicator Description End indicator. XtraDry indicator. Salt indicator. It is always off while the programme operates. BEAM-ON-FLOOR The Beam-on-Floor is a light that shows on the kitchen floor below the appliance door. • When the programme starts, a red light comes on and stays on for all the duration of the programme. • When the programme is completed, a green light comes on.
PROGRAMMES Consumption values 1) Programme Degree of soil Type of load Programme phases Duration (min) 2) 3) 4) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 240 0.921 9.9 All Crockery, cutlery, pots and pans • • 45 - 160 0.7 - 1.5 7 - 12 • • Prewash Wash from 45 °C to 70 °C Rinses Dry Heavy soil Crockery, cutlery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 140 160 1.4 - 1.6 13-15 Fresh soil Crockery and cutlery • 30 0.
• Bring the appliance back to the programme selection mode. To CANCEL: Press and hold simultaneously , , and The indicators: start flashing. As the appliance stores the saved settings, there is no need to configure it before every cycle. and until the control panel indicates the appliance is in the programme selection mode. ADJUSTING THE WATER SOFTENER Make sure the appliance is in user mode.
2. Press to change the setting. 3. Press on/off to confirm and save the setting. HOW TO DEACTIVATE AIRDRY AirDry improves the drying results with less energy consumption. By default, AirDry is activated with all programmes excluding (if applicable), but it is possible to deactivate it. Make sure the appliance is in user mode. 1. Press . The indicators: The indicator and are off. still flashes. The indicator indicates the current setting. If on = AirDry is on, if off = AirDry is off. 2.
ADDING RINSE AID 1 43 21 A 2 The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse phase. Fill the rinse aid dispenser when the indicator (A) becomes clear. DAILY USE 1. Open the water tap. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the salt indicator is on, fill the salt container. 3. Load the baskets. 4. Add the detergent. 5.
SETTING AND STARTING A PROGRAMME The AUTO OFF function This function decreases energy consumption by deactivating automatically the appliance when it is not operating. The function comes into operation: • 5 minutes after the completion of the programme. • After 5 minutes if the programme has not started. Starting a programme 1. Open the appliance door and keep it ajar. 2. Press on/off to activate the appliance. Make sure the appliance is in the programme selection mode. 3.
HINTS AND TIPS GENERAL The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if available) or select a programme with a prewash phase. • Always use the whole space of the baskets.
• The programme is applicable for the type of load and for the degree of soil. The correct quantity of detergent is used. • UNLOADING THE BASKETS 1. Let the tableware cool down before you remove it from the appliance. Hot items can be easily damaged. 2. First remove items from the lower basket, then from the upper basket. At the end of the program water can still remain on the sides and on the door of the appliance.
• To maintain the performance of your appliance at its best, we recommend to use monthly a specific cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product. TROUBLESHOOTING If the appliance does not start or it stops during operation, before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems the end indicator flashes intermittently indicating a malfunction.
Problem and alarm code Possible cause and solution The program lasts too long. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable). The appliance door is not centred on the tub. Adjust the rear foot (if applicable). • The appliance door is difficult to close. • • Rattling/knocking sounds from inside the appliance.
Problem Possible cause and solution There are whitish streaks or bluish layers on glasses and dishes. • There are stains and dry water drops on glasses and dishes. • The dishes are wet. • • • • • • • The release quantity of rinse aid is too much. Adjust the rinse aid level to a lower level. The quantity of detergent is too much. The released quantity of rinse aid is not sufficient. Adjust the rinse aid level to a higher level. The quality of the rinse aid can be the cause.
Refer to "Before first use", "Daily use" or "Hints and tips" for other possible causes. TECHNICAL INFORMATION Dimensions Width / height / depth (mm) 596 / 818 - 898 / 550 Electrical connection 1) Voltage (V) 220 - 240 Frequency (Hz) 50 Water supply pressure Min. / max. bar (MPa) 0.5 (0.05) / 8 (0.8) Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 13 Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.
156915420-A-092017 WWW.ZANUSSI.