User manual

ManualsBrandsZanussi ManualsToysZDV14002FA

These settings will be saved until you change them

again.

How to set the programme selection mode

The appliance is in programme selection mode

when only the indicator of the programme

is on.

When you activate the appliance, usually it is in

programme selection mode. However, if this does

not happen, you can set the programme selection

mode in the following way:

Press and hold simultaneously

and until

the appliance is in programme selection mode.

THE WATER HARDNESS TABLE

German degrees

(°dH)

French degrees

(°fH)

mmol/l Clarke degrees

Water softener

level

47 -50 84 - 90 8.4 - 9.0 58 - 63 10

43 - 46 76 - 83 7.6 - 8.3 53 - 57 9

37 - 42 65 - 75 6.5 - 7.5 46 - 52 8

29 - 36 51 - 64 5.1 - 6.4 36 - 45 7

23 - 28 40 - 50 4.0 - 5.0 28 - 35 6

19 - 22 33 - 39 3.3 - 3.9 23 - 27

15 - 18 26 - 32 2.6 - 3.2 18 - 22 4

11 - 14 19 - 25 1.9 - 2.5 13 - 17 3

4 - 10 7 - 18 0.7 - 1.8 5 - 12 2

<4 <7 <0.7 < 5

1) Factory setting

2) Do not use salt at this level.

How to set the water softener level

The appliance must be in programme selection

mode.

1. To enter the user mode, press and hold

simultaneously

and until the

indicators , and start to

flash.

2. Press .

• The indicators and go off.

• The indicator continues to flash.

• The end indicator starts to flash. The number of

flashes indicates the level.

– E.g. 5 flashes + pause + 5 flashes = level 5.

3. Press again and again to change the

setting. Each time you press the level

number increases. After level 10 you will start

again from level 1.

4. Press the on/off button to confirm the setting.

ACOUSTIC SIGNALS

Acoustic signals sound when a malfunction of the

appliance occurs. It is not possible to deactivate

these acoustic signals.

There is also an acoustic signal that sounds when

the programme is completed. By default this

acoustic signal is deactivated but it is possible to

activate it.

BEFORE FIRST USE

1. Make sure that the current level of the water

softener agrees with the hardness of the water

supply. If not, adjust the level of the water

softener.

2. Fill the salt container.