VENUSIAN e T INSTRUCTION BOOK DEPT) LIBRARY HASTE COPY s s sk Instructions for the use and care of ZE 942 R cooker B4
Contents Instructions for the owner Installation.. Technical data. Cooking procedure. Maintenance & cleaning. Instructions for the installer Installation. Electrical connection. Caution Before you start operating the appliance, be sure to remove the plastic film protecting the stainless steel or anodized aluminum parts. Important: During normal cooking operations the appliance will get very hot. Therefore, do not let children play near the appliance.
Instructions for the owner Installation It is mandatory that all operations required for the installation, the adjustments, the conversion to the type of gas available ete. be tarried out by QUALIFIED PERSONNEL in accordance with existing rules and regulations. The relevant instructions are to be found in the special chapter for the installer. This appliance meets the requirements laid down in EEC Directive No 76/889 dated 4/11/1976 relating to the suppression of radio and TV interference.
Use and care A Ceramic hob F Handle B Control panel G Oven door C Side grilles H Removable base D Grilles I Front panel E Dripping pan L Removable drawer M Residual heat light
Control panel 1 Programmer 5 Front left heat zone control knee 2 Thermostat light 6 Rear left heat zone control knob 3 Oven knob 7 Rear right heat zone control knob 4 Grill knob 8 Front right heat zone control knob ) Removable grill R Oven light S -Fan T Filter U Enameled panels
Operation Ceramic-glass hob This hob consists in a perfectly flat surface, made of a special material resistant to high temperatures and to shocks, "The heating elements are placed under the ceramic-glass surface, in contact with it, directly underneath the silk-screened areas on the hob itself.
Using the oven As soon as the oven is switched on the fan starts and runs until the oven control is switched off again (fig.2). The food should be put into the oven before switching on, even when cooking manually the speed of heating up is so fast that there is no need to preheat. The oven shelves can be fully filled. Most normal types and materials of cooking utensils can be used. During cooking the door should be opened as little as possible to avoid heat loss and $0 excessive electricity consumption.
Automatic timer The automatic timer makes it possible for the oven and/or front left hot plateful area to be turned on and off automatically at the per-set time. Furthermore, the timer will show the time of the day and will also ring a bell at the end of the cooking cycle. Operating the automatic timer The figure 8 shows the control knobs of the automatic timer. With knobs 1,2 and 3 you can carry out all required adjustments, as described hereunder.
Important: When the cooking time has elapsed, turn knob 2 clockwise until the “0° coincides with the index on dial 4, Then turn the control knob Turn the thermostat knob and/or hot plateful area knob to ‘0% Fully automatic operation Place the food to be cooked in the oven and for on the hot plate/heat area. Turn knob 2 clockwise and set the required cooking time (max. 210 mind) on ial 4. Depress knob 3 and turn it clockwise until the cooking start time appears on dial 5.
Using the grill As with the oven the grill control {(see Fig.4) can be set to a number of different heat settings. At MAX the thermostat controlling the heat does not operate and the element stays on continuously to give the highest heat possible Foods to be grilled are placed on the wire grid in the grill pan, which can be curved either upwards or downwards to give the required distance from the element.
Figure 5 Ages Useful hints for the fis% of ceramic-glass 0 "The max. efficiency and the maximum service life of the appliance is obtained by using it correctly. The most important characteristic of the special glass-ceramic surface is to transmit vertically all the heat of the underlying heating element, without vertical loss of heat. In this way it is possible to make use of all the power supplied and to have the areas adjoining the cooking areas with a lower temperature.
Cooking possibilities on the ceramic hob Any kind of cooking operations can be easily carried out on the ceramic hob. Obviously, the complete knowledge and the appreciation of the countless cooking possibilities of the hob will be possible only by using it and by checking out the results of the first cooking operations. Residual heat light The ceramic hob incorporates a control light showing the residual heat.
To use the grill Open the door and put the heat deflector in position. Turn the oven control (Fig.2) to 3 and then set the grill control to the jest setting required. Little use and practice will soon show which heat setting is the best for the individual user. When grilling is over remove the heat deflector and shut the door. Safety thermostat "This device cuts out the electricity supply in case of failure of the temperature control, and thus prevents the hazard of overheating.
Upkeep and cleaning Important: before undertaking any cleaning or up keeping operation, be sure tn have the appliance disconnected from the electric supply. For a long service life of the appliance, we strongly recommend that you frequently carry out a thorough cleaning operation. The hob cleaning operations can be easily done by using a damp cloth or one of the normal products available on the market (never use coarse or abrasive products).
Removing the panels Proceed as follows: Unplug and remove the grill element; Unscrew the fixing ring nuts of the side runners, remove the runners and lift the side panels of their pins. Remove the top panel by lifting it off, Remove the resews securing the back panel and lift it out. Replacing the oven light bulb Disconnect the appliance from the electric supply. Unscrew the light bulb glass protection from the oven.
Instructions for the installer Installation The following instructions are meant for a qualified installer and should assist him in carrying out all installation, adjustment and maintenance operations in the most correct way and in accordance with existing laws and regulations, Important: Before servicing the appliance or undertaking any maintenance work on it, be sure to disconnect it from the electric supply.
Figure § The appliance incorporates a set of . adjustable feet. By properly adjusting the feet, the appliance can be set up at the required height and correctly aligned with the kitchen furniture or any other surface, thus ensuring an even spreading out of liquids in pans and pots. These adjustable feet are easily accessible after removing the dish-warming drawer.
Electrical connection The appliance is designed to operate on alternating current, with a single phase voltage of 240V-50Hz. The electric supply cable has to be connected to the terminal board placed under the cover on the back of the appliance. The oven terminal board has the following markings: L = Live N = Neutral + = Earth The ground wire has to be green & yellow colored.
What happens if something goes wrong Power cuts Should the electricity supply fail for any reason remember to reset the electronic clock to the right time when the power is resumed. If the cooker does not come on when cooking manually, first check that the programmer is set for manual, Le.
ZANINESS! ELECTROMAGNETIC Industries Gaussian spa GAUSSIAN GUARANTEE CONDITIONS "This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of the enclosed card.