EN User Manual Hob ZEE6940FWA
Contents Safety information Safety instructions Product description Daily use Hints and tips 2 3 5 5 6 Care and cleaning Troubleshooting Installation Technical information Energy efficiency 6 6 7 8 9 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • • • • • Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
• • • • If the mains socket is loose, do not connect the mains plug. Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. Use only correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors. The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm.
Product description Cooking surface layout 1 Cooking zone 2 Control knobs 3 Power indicator 1 1 1 180 mm 180 mm 145 mm 145 mm 3 1 2 Residual heat Control knob Symbol Function 0 Off position 1-6 Heat settings WARNING! There is a risk of burns from residual heat. Daily use WARNING! Refer to Safety chapters. Before first use Put cookware containing water on each cooking zone, set the maximum position and operate the hob for 10 min. This is to burn off the residue in the appliance.
Hints and tips WARNING! Refer to Safety chapters. Heat setting: Cookware The bottom of the cookware must be as thick and flat as possible. CAUTION! Do not use cast iron pans, potstones, earthenware, grill or toaster plates. The stainless steel can become tarnished if it is too much heated.
What to do if... Problem Possible cause You cannot activate or operate the hob. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram. The fuse is released. Make sure that the fuse is the cause of the malfunction. If the fuse releases again and again, contact a qualified electrician. If you cannot find a solution... also during the warranty period.
Model ....................................... PNC ......................................... Serial number ........................... A Built-in hobs Only use the built-in hobs after you assemble the hob into correct built-in units and work surfaces that align to the standards. B Connection cable • For a single phase or two phase connection use the following (or higher) mains cable type: H05BB-F Tmax 90°C.
Energy efficiency Product information according to EU 66/2014 Model identification ZEE6940FWA Type of hob Built-In Hob Number of cooking zones 4 Heating technology Solid Hot Plate Diameter of circular cooking zones (Ø) Left front Left rear Right front Right rear 14.5 cm 18.0 cm 14.5 cm 18.0 cm Energy consumption per cooking zone (ECelectric cooking) Left front Left rear Right front Right rear 210.0 Wh / kg 195.0 Wh / kg 210.0 Wh / kg 210.
www.zanussi.
www.zanussi.
867311221-A-322014 www.zanussi.