User manual

• The appliance becomes too hot (e.g. when, a
saucepan boils dry). Before you use the ap-
pliance again, the cooking zone must be
cool.
•
You use incorrect cookware. The symbol
comes on and the cooking zone deactivates
automatically after 2 minutes.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deactivates.
See below.
• The relation between heat setting and times
of the Automatic Switch Off function:
•
, - — 6 hours
•
- — 5 hours
•
— 4 hours
•
- — 1.5 hours
The heat setting
Touch
to increase the heat setting. Touch
to decrease the heat setting. The display
shows the heat setting. Touch
and at the
same time to deactivate the cooking zone.
Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automatic Heat
Up function. This function sets the highest heat
setting for some time (see the diagram), and
then decreases to the necessary heat setting.
To start the Automatic Heat Up function for a
cooking zone:
1.
Touch
. The symbol comes on in the
display.
2.
Immediately touch
. The symbol
comes on in the display.
3.
Immediately touch
again and again until
the necessary heat setting comes on. After
3 seconds
comes on in the display.
To stop the function, touch
.
1
2
3
4
5
6
7
8
9
10
11
0
123456789
Power function
The Power function makes more power availa-
ble to the induction cooking zones. The Power
function can be activated for a limited period of
time ( see Technical Information chapter). After
that, the induction cooking zone automatically
sets back to highest heat setting. To activate,
touch
, comes on. To deactivate, touch
or .
Power management
The power management divides the power be-
tween two cooking zones in a pair (see the il-
lustration). The power function increases the
power to the maximum level for one cooking
zone in the pair. The power in the second cook-
ing zone automatically decreases. The heat set-
ting display for the reduced zone changes be-
tween two levels.
7
www.zanussi.com