User manual

What to do if…
Problem Possible cause and remedy
You cannot activate the appliance or
operate it.
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one
sensor field.
• The Child Safety Device or the Lock operates. See the chapter Operating
instructions.
• There is water or fat stains on the control panel. Clean the control panel.
A Sound operates and the appliance
deactivates.
A sound operates when the appliance
is deactivated.
You put something on one or more sensor fields. Remove the object from the
sensor fields.
The appliance deactivates.
You put something on the . remove object from the sensor field.
The residual heat indicator does not
comes on.
The cooking zone is not hot because it operated only for a short time. If the
cooking zone should be hot, speak to the service centre.
The Automatic Heat Up function does
not operate.
• There is still residual heat on the cooking zone. Let the cooking zone be-
come sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same pow-
er as the Automatic Heat Up function.
The heat setting changes between two
levels.
The Power management is activated. See the section Power management.
The sensor fields become hot. The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
comes on
The Automatic Switch Off operates. Deactivate the appliance and activate it
again.
comes on
• No cookware on the cooking zone. Put cookware on the cooking zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the cooking
zone. Move cookware to a smaller cooking zone.
and number comes on.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Disconnect
the fuse from the electrical system of the house. Connect again. If
comes
on again, speak to the service centre.
comes on
There is an error in the appliance, because a cookware boils dry. The protec-
tion against become too hot for the cooking zone operates. The Automatic
Switch Off operates.
Deactivate the appliance. Remove the hot cookware. After, approximately 30
seconds activate the cooking zone again.
should go out of the display,
residual heat indicator can stay. Let the cookware become sufficiently cool
and check it with the section Cookware for the induction cooking zone.
11