Operating instructions

h. The “minutes” will be flashing. Use the Up/Down keys to set the minutes then press and
release the OK key.
i. “TIMER X Mod.?” is displayed. Press and release the desired Mode key (TV, VCR, DVD, etc.).
j. “TIMER X EING1” is displayed. Press and release the first key required. If only one key is
required, press and release OK at this point – go to Step “m” below.
k. “TIMER X EING2” is displayed. Press and release the second key required. If only two keys are
required, press and release OK at this point – go to Step “m” below.
l. “ TIMER X EING3 ” is displayed. Press and release the third key required.
m. “FERTIG” will be displayed and the remote will remain in Setup, returning to the
“CODE SETUP” screen.
Set the remote control down on a table or flat surface at the level of the TV set’s infrared receiver
with its front end pointed toward the device to be controlled.
Press and release the Exit key at any time during the Setting to return to normal operation.
To clear a Timer (“Timer Bell” in normal display)
a.
Press and hold Setup key until “CODE SETUP” is displayed (takes approximately 2-3 seconds).
b. Release Setup key.
c. Navigate to “TIMER SETUP” by pressing the Setup key 2 times. Press and release OK key.
d. “SLEEPTIM.TV” is displayed.
e. Navigate to the desired “TIMER X SETUP” (where “X” is 1, 2, 3 or 4) screen. Press and release
the OK key.
f. “TIMER X AUS” is displayed. Press and release the OK key.
g. “AUS BEST.” is displayed. Press and release the OK key.
h. “FERTIG” will be displayed and the remote will remain in Setup, returning to the “CODE
SETUP” screen.
Learning function
If the make of the device you wish to control is not in the separate code list or if some functions
are missing in the code you have programmed, you can copy the key functions of the original
remote control of the device into your LCD remote control. Depending on the format of the
transmission codes of the original remote control, your LCD remote control can memorise up to
150 keys.
Tips On Learning:
a. Where possible, use of fresh batteries for both remotes is recommended.
b. Only one original remote type can be learned per individual Mode.
c. Clear all learned commands (Loeschen Alles) before attempting any Learning.
d. Experiment by Learning 2 or 3 keys initially (to ensure compatibility and familiarity) and then
Clear all learned commands (Loeschen Alles) before completely Learning your original
remote’s keyboard.
e. Carry out a “Mode Clear” (Loeschen Modus) before learning a Mode to make sure there are
no previously learned commands for that Mode.
f. Place the remotes end-to-end so the IR LED’s on both remotes are directly in line with each
other. You may need to adjust the height of either remote to achieve this.
g. Keep the distance between the two remotes to approximately 25mm.
23

Lernen Set
Setup
왘
Lernen Set
Modus
왘
Quellen- Set
Taste
왘
Lernen Set
Taste
왘
Orig.-FB Set
Taste
왘
Fertig Set
왘
Lernen Set
Mehr?
왖
or
왘
Lernen Set
Fehl.
왘
왔
Loeschen- Set
Modus
왘
Quellen- Set
Taste
왘
Loeschen Set
Best.
왘
Warten.. Set
왘
Fertig Set
왘
왖
왔
Loeschen- Set
alles
왘
Loeschen Set
Best.
왘
Warten.. Set
왘
Fertig Set
55415 BedienAnltg TeFu_Zweite Version 08.12.09 16:33 Seite 23