User manual

Problem Possible cause Solution
There is no voltage in the
mains socket.
Connect to a different electri-
cal mains socket. Contact a
qualified electrician.
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands
stable.
Audible or visual alarm is on. The cabinet has been recently
switched on or the temperature
in the appliance is too high.
Refer to "High Temperature
Alarm" and if the problem still
occurs contact the nearest Au-
thorized Service Centre.
Power indicator light is flash-
ing.
An error has occurred in meas-
uring the temperature or the
appliance is not working prop-
erly.
Contact the nearest Author-
ized Service Centre.
The lid doesn't close complete-
ly.
Food packages are blocking
the lid.
Arrange the packages in the
right way, see the sticker in the
appliance.
There is excessive frost. Eliminate excess frost.
The lid is difficult to open. The lid gaskets are dirty or
sticky.
Clean the lid gaskets.
The valve is blocked. Check the valve.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
The compressor operates con-
tinually.
Temperature is set incorrectly. Refer to "Operation" chapter.
Large quantities of food to be
frozen were put in at the same
time.
Wait some hours and then
check the temperature again.
The room temperature is too
high.
Refer to climate class chart on
the rating plate.
Food placed in the appliance
was too warm.
Allow food to cool to room
temperature before storing.
The lid is not closed properly. Check if the lid closes well and
the gaskets are undamaged
and clean.
There is too much frost and
ice.
The lid is not closed correctly
or the gasket is deformed/dirty.
Refer to "Closing the door".
The water drainage plug is not
correctly positioned.
Position the water drainage
plug in the correct way.
Temperature is set incorrectly. Refer to "Operation" chapter.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
19