EN User manual Freezer ZFT11110XA
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful Hints and Tips _ _ _ _ _ _ _ _ _ _ _ _ 2 4 6 6 6 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environmental concerns _ _ _ _ _ _ _ _ _ _ 12 Subje
ponents of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock.
immediately to the place you bought it. In that case retain packing. It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation follow the instructions relevant to installation.
7. be stopped by pressing the Acoustic Signal Stop and Fast Freeze Switch once. When switching on the freezer for the first time, the Red Alarm Indicator Light will blink until the internal temperature has reached a level required for the safe conservation of frozen food. Switching off 1. To turn off the appliance, turn the Temperature Regulator to the "O" position. 2. To disconnect the appliance from the power disconnect the mains plug from the wall socket.
First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish. Daily use Freezing fresh food The freezer compartment (the top box) is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.
• water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt; • it is advisable to show the freezing in date on each individual pack to enable you to keep tab of the storage time.
Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete. 4. 5. 6. 7.
Problem Possible cause Solution Large quantities of food to be frozen were put in at the same time Wait some hours and then check the temperature again Food placed in the appliance was too warm Allow food to cool to room temperature before storing The room temperature is too high.
3. If necessary, replace the defective door gaskets. Contact the Service Center. Technical data Dimension Height 850 mm Width 595 mm Depth 635 mm Rising Time 24 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
tween the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. Warning! Door reversibility Important! To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. min. 100 mm 15 mm It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
A B C D E Important! The wires in the mains lead are coloured in accordance with the following code: A Green and Yellow: Earth C Brown: Live D Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the col- oured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the or colletter “E“ or by the earth symbol oured green and yellow. 2.
www.zanussi.
www.zanussi.
www.zanussi.
212000268-A-042013 www.zanussi.