User manual

3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height 1250 mm
Width 545 mm
Depth 640 mm
Rising Time 18 h
Voltage 230 V
Frequency 50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry, well
ventilated indoor where the ambient tempera-
ture corresponds to the climate class indicated
on the rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for some
types of models when operating outside of that
range. The correct operation can only be guar-
anteed within the specified temperature range. If
you have any doubts regarding where to install
the appliance, please turn to the vendor, to our
customer service or to the nearest Service Cen-
tre
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
1. Fit the spacers
into the holes.
Make sure that
the arrow (A) is
positioned as
shown in the pic-
ture.
2. Turn counter-
clockwise the
spacers through
45° until they
lock into place.
45˚
A
10
www.zanussi.com