User manual

Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
1. Remove the plinth.
2. Unscrew and re-
move the lower hing-
es.
3. Remove the door.
2
1
4. Unscrew the upper
pin and screw it on
the opposite side.
5. Refit the door.
6. Make sure the
edge of the door is
parallel with the edge
of the top.
A
B
7. Unscrew the pin
(A) and screw it on
the opposite side.
8. Remove the cap
(B) and position it on
the opposite side.
9. Screw the lower
hinges.
10. Refit the plinth.
11. Stand the appli-
ance upright.
12. Fit the handle on
the opposite side and
put the plastic caps
(contained in the in-
structions bag) in the
free holes.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
Environmental concerns
The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
11
www.zanussi.com