User manual

E
1
F
2
5
3
4
1. Remove the door.
2. Remove using a tool the cover (e),
unscrew the lower hinge pivot (f) and
place it on the opposite side.
3. Re-insert the cover (e) on the op-
posite side.
4. Re-insert the door.
5. Pay attention that the front board of
the doors are parallel to the front
board of the top.
6. Fix the door stopper on the oppo-
site side.
7. Position and fix the upper hinge
(that can be found in the instruction
for use bag) on the opposite side .
8. Fix the screw of the new cover
hinge (that can be found in the in-
struction for use bag).
9. Unscrew the pin and screw it back
on the other side.
10. Remove the covers on the top of
the door and fit it on the opposite
side.
11. Fit the door into the pins and in-
stall the door. Install the bottom
hinge.
12. Tighten the hinge.
13. Remove the plastic caps.
14. Unscrew the handle.
15. By a screwdriver with 2,5 mm di-
ameter drill the cover on the opposite
side.
16. Fit the handle on the opposite
side and put the plastic caps (con-
tained in the instructions bag) in the
free holes
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
10