User manual

Location

The appliance should be installed well away from sources

of heat such as radiators, boilers, direct sunlight etc. En-

sure that air can circulate freely around the back of the

cabinet. To ensure best performance, if the appliance is

positioned below an overhanging wall unit, the minimum

distance between the top of the cabinet and the wall unit

must be at least 100 mm . Ideally, however, the appliance

should not be positioned below overhanging wall units.

Accurate levelling is ensured by one or more adjustable

feet at the base of the cabinet.

If the cabinet is placed in a corner and the side with the

hinges facing the wall, the distance between the wall and

the cabinet must be at least 10 mm to allow the door to

open enough so that the shelves can be removed.

min.100 mm

15 mm

Warning! It must be possible to disconnect the ap-

pliance from the mains power supply; the plug must

therefore be easily accessible after installation.

Electrical connection

Before plugging in, ensure that the voltage and frequency

shown on the rating plate correspond to your domestic

power supply.

The appliance must be earthed. The power supply cable

plug is provided with a contact for this purpose. If the do-

mestic power supply socket is not earthed, connect the

appliance to a separate earth in compliance with current

regulations, consulting a qualified electrician.

The manufacturer declines all responsibility if the above

safety precautions are not observed.

This appliance complies with the E.E.C. Directives.

Rear spacers

In the bag with the documentation, there are two spacers

which must be fitted as shown in the figure.

Slacken the screws and insert the spacer under the screw

head, then retighten the screws.

Door reversibility

Important! To carry out the following operations, we

suggest that this be made with another person that will

keep a firm hold on the doors of the appliance during the

operations.

To change the opening direction of the door, do these

steps:

• Remove the plug from the power socket.

• Tilt back the appliance carefully so that the compressor

cannot touch the floor.