User manual

The ventilation space can
be:
• directly above the ap-
pliance
• behind and above the
top cupboard.
In this case, the space
behind the top cup-
board must be at least
50 mm deep.
50mm
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Removing the transport support
Your appliance is equipped with transport support to se-
cure the door during transportation.
To remove them do these steps:
1. Open the door.
2. Remove the transport
support from the
door sides.
3. Remove the transport
support from the
lower hinge (some
models).
3
2
Important! Some models are fitted with a silencing pad
under the cabinet. Do not remove this pad.
Levelling
When placing the appli-
ance ensure that it stands
level. If necessary adjust
the feet using the adjust-
ment spanner supplied.
Door alignment is depend-
ent on proper levelling.
Door reversibility
To change the opening direction of the door, do these
steps:
• Remove the plug from the power socket.
• Remove the ventilation grille. Remove the filling and
install it on the opposite side of the grille.
• Lay down the appliance back side down on a wooden
support.
• Unscrew the upper hinge
(a1) and the cover washer
(a2) and install this on
the opposite side.
• Unscrew the lower hinge.
Change the position of
the pin and buffert. Screw
the lower hinge on the
opposite side.
• Tighten the pin with the
adjustment spanner sup-
plied.
• Raise the appliance and
install the ventilation
grille.
• Unscrew the handle. On
the opposite side remove
the hole covers by driving
a 3-4 mm drift or drill in-
to them. Install the han-
dle.
Install the hole covers provided within the accessory
bag.
a1
a2
10