User manual

Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol
are recyclable.
Control panel
1 2 3
45
1 Temperature indicators
2 Fast Freeze light
3 Alarm light
4 Alarm reset button /
Fast freeze button
5 ON/OFF /
Temperature set button
Switching on
Insert the plug into the wall socket.
If the Temperature indicator is not illuminated, press ON/
OFF button.
If the temperature inside the appliance is too warm the
Alarm light will flash and the Alarm buzzer starts.
Press the Alarm reset button to switch off the Alarm buzzer
Switching off
1. Press the ON/OFFbutton for few seconds.
2. All Temperature indicators will light up and then
count down in 3 steps.
3. Disconnect the mains plug from the mains socket to
disengage the appliance completely.
Temperature regulation
1. Press the Temperature set button.
The temperature indicator will flash.
2. Select a new temperature by pressing the Tempera-
ture set button repeatedly.
3. The Temperature indicator will stop flashing after a
while.
The temperature indicator shows the set temperature.
The set temperature will be reached within 24 hours.
Keep in mind that the temperature inside the appliance al-
so depends on:
• room temperature
• how often the door is opened
• quantity of food stored
• location of the appliance.
Fast Freeze function
1. Press the Fast Freeze button.
2. The Fast Freeze light will light up.
4