User manual

Problem Possible cause Solution
The appliance is noisy. The appliance is not supported prop-
erly.
Check if the appliance stands stable (all
feet and wheels should be on the floor).
Refer to "Levelling".
The buzzer sounds. The Alarm
light flashing.
The temperature in the freezer is too
high.
Refer to "Temperature Alarm"
Three Temperature indicators
flashing.
An error has occurred in measuring
the temperature.
Call your service representative (the
cooling system will continue to keep
food products cold, but temperature ad-
justment will not be possible).
The compressor runs continu-
ously.
The Temperature regulator may be set
incorrectly.
Set a warmer temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer than
necessary.
The food temperature is too high. Let the food temperature decrease to
room temperature before storage.
The room temperature is too warm. Decrease the room temperature.
There is too much frost and ice. Food are not wrapped properly. Wrap the food better.
The door is not closed correctly. Refer to "Closing the door".
The door gasket is deformed or dirty. Refer to "Closing the door".
The Temperature regulator may be set
incorrectly.
Set a warmer temperature.
The temperature in the appliance
is too cold.
The Temperature regulator may be set
incorrectly.
Set a warmer temperature.
The temperature in the appliance
is too warm.
The Temperature regulator may be set
incorrectly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too high. Let the food temperature decrease to
room temperature before storage.
The temperature in the freezer is
too warm.
Food is too near to each other. Store food so that there is cold air circu-
lation.
Large quantities of food to be frozen
were put in at the same time.
Insert smaller quantities of food to be
frozen at the same time.
The appliance does not operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the
mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
Connect another electrical appliance to
the mains socket. Check fuse. Contact a
qualified electrician.
8