User manual

7
Operation
Hob burner control knobs
The symbols on the knobs mean:
" = no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
Lighting the burners
To light a burner, , press the relevant
switch marked with a small spark ( ).
Then, push in the relevant knob and
turn it anticlockwise to "maximum posi-
tion".
Check the flame is regular and
adjust it as required.
If you cannot light the flame even
after several attempts, check the "cap"
and “crown” (see picture - lett. A, B)
are in the correct position.
In the absence of electricity, igni-
tion can occur without the
electrical device; in this case
approach the burner with a
flame, push the relevant knob
down and turn it anti-clockwise
until it reaches the "maximum"
position.
To switch off burners
To put the flame out, turn the knob to
the symbol (").
Take care when frying food in
hot oil or fat, as the overheated
splashes could easily ignite.
When switching on the mains, after
installation or a power cut, it is qui-
te normal for the spark generator to
be activated automatically.
!
!
A - Burner cap
B - Burner crown
C - Ignition candle