User manual

14
K
Fitting the Cooker Hood to the Wall
1. Fit the brackets with the round ends
facing downwards using the plastic rawl
plugs and screws provided.
2. Once the brackets are secured, lift the
hood squarely to the wall slightly higher
than the brackets. Lower the cooker hood
until it is located onto the two brackets.
Ensure that the cooker hood is correctly
located before letting go.
3. By loosening the screws in the extension
arm the hood can be aligned with the
front of the adjoining wall cabinets.
4. The hood should be secured on each
side to the adjoining wall cabinets using
the 4 x 15mm (
1
/
2
ins) security screws
provided.
5. Adjust the lower spacer panel at the rear
of the hood to close the gap to the wall.
Decor Panel
The dimensions of the door panel should be
59.6cm (23
1
/
2
ins) wide by 35cm (13
1
/
2
ins) in
height.
K
Fitting a Decor Panel to the Hood Visor
1. Remove the complete visor assembly by
pulling open into the operating position,
simultaneously press down on the release
catch located behind the visor on the left
hand side of the casing.
2. Using the paper template provided, mark
the screw hole positions on the reverse
side of the decor panel. Ensure that the
paper template is aligned with the top
edge of the decor panel.