User manual

60
Wall mounting
• Mark a centre line on the wall (1).
• Fix the drilling template to the wall (2).
• Make 4 holes in the wall as indicated on the
template (3a).
Extraction mode only:
If you wish to use the rear exhaust outlet on
the hood, make a hole in the wall so that the
exhaust pipe can pass through it (3b).
• Insert 4 rawl plugs into the holes you have
made (4).
• Insert two 5 x 45 screws into the upper holes
(5) but do not tighten them completely (6).
• Hook the hood onto the screws.
• Adjust the unit so that it is positioned at a right
angle to the wall by turning the two screws on
lower side (7).
• Tighten the 2 upper screws (8).
• Insert 2 screws into the lower holes (9) from
inside the hood, then tighten all the screws
fully (10).
2
3a
4
4
4
5
5
3a
1
3b
6
6
9
8
1cm
5 !
10
8
7
7