Instruction Manual

WARNINGS - COMPONENTS

WARNINGS

This appliance has been designed for use as either an EXTRACTION (ducting to the outside) or RE-

CIRCULATION (filtering) hood. The measurements contained on the drawings in this booklet refer to

two models of cooker hood. Therefore, it is essential that you refer to the correct drawing when taking

measurements for installation.

- The minimum distance between the cooking surface and the metal grease filters on the underside of the

hood must be 650mm.

- This cooker hood must be installed in accordance with the installation instructions and all requirements

must be adhered to.

- If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heat-

ing boiler then its flue must be of the room sealed or balance flue type.

- If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.

- When the range hood and appliance supplied with energy other than electricity are simultaneously in

operation, the negative pressure in the room must not exceed 4 Pa (4x10-5 bar).

- Exhaust air may be discharged in accordance with official and statutory regulations only (e.g. national buil-

ding regulations).

- The ducting system for this appliance must not be connected to any ventilation system which is being

used for any other purpose.

- The ducting system for this appliance must not be connected to any existing ventilation system which is

being used for any other purpose.

- Do not leave naked flames or carry out flambè cooking under this cooker hood.

- This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or in-

struction concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure that they do not play with the appliance

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall

be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is

disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could o-

therwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, plea-

se contact your local city office, your household waste disposal service or the shop where you purchased the product.

CONNECTING THE POWER CABLE TO THE MAINS POWER SUPPLY

Before installation, check that the mains voltage indicated on the rating plate inside the appliance corre-

sponds to the voltage available in your home. If the Hood is not fitted with a plug, fit the power cable with

a plug of a type approved for the load indicated on the rating plate; when connecting directly to the mains,

insert an omnipolar circuit breaker with a minimum contact aperture of 3mm and a size suitable for the

load in question between the appliance and the mains supply, making sure it is of a type that complies with

current regulations.

COMPONENTS

- 2 No Wall Brackets C

- 1 No 150-120mm Ducting Spigot G

- 1 No Air Outlet Connection H (Optional)

- 2 No Charcoal Filters L (Optional)