Specifications

17
PR266
A
B
C
D
6. Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws
supplied.
20mm
A
50mm
PR166
PR33/2
C
A
8. Open the appliance door and the furniture door at
90¡. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with ¯ 2 mm
at 8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
8mm
PR167
A
B
9. Should the alignment of the furniture door be
necessary, use the clearance of slots.
At the end of this procedure, it is necessary to
check if the door of the furniture closes properly.
PR168
10. Fix cover (D) on guide (B) until it clips into place.
PR167/1
D
B
5. Separate parts A, B, C, D as shown in the figure.
7. Fix cover (C) on guide (A) until it clips into place.