REFRIGERADORCONGELADOR FRIDGE-FREEZER FRIGORÍFICOCONGELADOR ZIC 722/9 LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES 2222 284-11
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation ■ Positioning ■ Cleaning the interior ■ Instructions for totally built-in appliances ■ Electrical connection Technical specification Use 13 13 13 14 16 16 17 ■ Starting 17 ■ Quick-freezing ■ ■ Warning light Freezing fresh food ■ Storage of frozen food ■ Thawing ■ Ice-cube production ■ Temperature regulation 17 17 17 18 18 18 18 GB ■ Fresh food refrigeration ■ Movable shelves ■ Positioning the door shelves ■ Air circulation ■ Defrosting Maintenance ■
I nstructions for totally built-in appliances Door reversibility (Fig. 1) P P A D B C D C P1 P1 D337 Right opening Left opening Remove the pins (P) and (P1) Remove (P) from both sides and the door. Remove (A) from the left side and (B-C-D) from the right side. Refit (B-C-D)on the left side and (A) on the right side. Refit the door and (P) on the left side and remove (P1) from the right side.
If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 A D265 Fig. 5 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. of 2 mm. Replace the little platee over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes.
USE GB This freezer has been marked with the symbol, which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. The control panel 2 1 3 D A. Pilot light B. SUPER operating control light C. Warning light D. Normal/Super (quick-freezing) switch E. Thermostat knob Starting Insert the power supply plug into the nearest wall socket (the function indicator light (A) will light up indicating that the freezer is receiving electrical input).
Storage of frozen food To obtain the best performance from this appliance, we strongly recommend that you make sure that the commercially frozen foodstuffs were adequately stored by the retailer and, furthermore, be sure that these frozen foodstuffs are transferred from the foodstore to the consumer in the shortest possible time (a temperature increase of the frozen food could shorten its storage period). It is also advisable not to exceed the storage period indicated by the producer of the food.
Fig. 13 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. D009 Fig. 14 Air circulation D007 Inside the appliance, there is a fan (DAC) which is turned on by means of the illuminated switch.
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: Internal cleaning Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. External cleaning Wash the outer body with lukewarm water and soap.