User manual

17
Installation
PPoossiittiioonniinngg
• Place the refrigerator away from direct sunlight and
heat sources.
• Maintain recommended ventilation
• Make sure the refrigerator is accurately levelled tur-
ning the adjustable feet in order to avoid vibrations
and noises.
• In the documentation bag you will find two spa-
cers that must be mounted as shown in the
figure in the back of your appliance.
Please loosen the screw under its head and
then unloosen again.
• This is a built in design to be aligned with other furni-
ture
CClleeaanniinngg tthhee iinntteerriioorr
• Do not use alcohol or any cleanig product containing
alcohol because it can damage the cabinet.
• Before using the appliance for the first time wash the
interior whith luke warm water and some neutral soap
so as to remove the typical smell of a brand-new pro-
duct arid then dry thoroughly.
• Do not use detergents or abrasive powders as these
will damage the finish.
• Remove security used for transportation.
EElleeccttrriiccaall ccoonnnneeccttiioonn
mBefore plugging the appliance make sure that the vol-
tage and frequency shown on the «Technical
Features» correspond to your home supply.
mIt is essential that the appliance be efficiently eart-
hed.
For this purpose the supply cable plug incorporates a
special earth contact. If the sockets of your domestic
wiring system are not grounded, have the appliance
connected to a separate ground wire in accordance
with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
Getting started
• Plug the appliance into the mains.
• Make sure the inner light turns on when opening
the door.
• Turn to intermediate position the knobs of the
«temperature regulators»: «A» for refrigerating
compartment and «C» for freezing compartment.
50mm
40mm
D594