Electric Ceramic-glass Hob ZKL 64 W - ZKL 64 B ZKL 64 N - ZKL 64 X Operating and Installation Instruction 319 3900-00 K/RD-SD 980223 GB
Important hints on safety Prior to the first use of the appliance do make yourself familiar with the instruction manual. Pay special attention to the hints on safety. In this manual they are marked with a . This will prevent from damages to persons as well as to the appliance itself. Do carefully keep the manual at a safe place and, if need be, pass it on to your successor user. The appliance is only to be used for its purpose in the household.
Overall view ZKL 64 W ZKL 64 B ZKL 64 N ZKL 64 X 1. cooking zone Ø 180 mm, 1700 W 2. cooking zone Ø 145 mm, 1200 W 3. cooking zone Ø 180 mm, 1700 W 4. cooking zone Ø 145 mm, 1200 W 5. Residual heat indicator 6. Hotplate switches Voltage AC 230 V Total connected load 5,8 kW Prior to the first use Please do check whether the appliance was delivered in perfect state. Appliances with obvious transport damages must not be connected to the mains.
Hob instructions Ceramic glass surface The cooking surface is made of proven ceramic glass. The surface is non--porous and, in addition, insensitive to quick variations in temperature. Therefore pots may be moved from a hot to a cold zone. When switching on the cooking zones there may occur a short--termed audible buzzing sound of the radiant elements. This sound is physically conditioned, without any harm to the performance of the appliance and fading away with sufficient heating of the cooking zone.
Residual heat indicator The residual heat indicator with 1 indicator lamp is located between the two front cooking zones. The lamp comes on in case the temperature of switched on cooking zones will reach more than (abt.) 60 oC. Also after switch--off the lamp will remain on until cooling down of the corresponding cooking zone. Pots and pans Do not put pots on the cooking surface unless their bottoms are clean and dry. Avoid heating up of empty vessels. Do always cook with the potlid closed.
Cleaning and care Clean your glass--ceramic hob thoroughly and regularly, when it is hand--hot or cold. Avoid frequent burning in of soiling. Suitable for cleaning are: Clean cloths or paper towels, cleansing agents such as cerafix, Stahl-fix, WK Top a.s.o. and a razor blade scraper supplied by the manufacturer. The cleaning scraper is applied at an angle towards the ceramic glass surface; residues from roasting and boiling over are to be scraped off with a sliding blade.
Installation instructions The appliance must exclusively be connected to the mains by an expert electrician. With the installation and in case of a service failure the appliance has to be isolated from the mains. Fuselage to be switched off or removed. The general rules for the operation of electric appliances, the provisions by the competent electricity supply board and the specifications of these instructions for installation have to be strictly adhered to.
When building in ceramic glass cooking areas the front cross-rail of the build-in cupboard must be removed in order to have the heat radiating off escape without any obstacles. The space under the hob unit must be closed at all sides in a way that the lower side of the cooking area is no longer accessible. The distance from the hob to the furniture part under the hob must at least amount to 20 mm. If needed, please fix an insulation. Drawers must not be located under a hotplate.
Electric connection The mains connection must be carried out by an expert electrician. The VDE-regulations and the valid prescriptions by the local power suppy boards have to be compiled with. Mains terminal in the bottom of the hob Prior to connection it should be checked whether the voltage stated on the type plate -- i.e. the nominal voltage of the appliance and of the oven/control box -- is identical with the prevailing mains voltage. The type plate ist located on the hobs bottom.
What to do in case of an error ? Put all selectors on the OFF-position. Spare parts service Fuselage to be switched off or unscrewed. Address: Tel.: Fax: Call an electrician or the after-sales service. Urgent ! Note down here the data from the type plate of your appliance. Same is to be seen on the bottom of your hob. Make always reference to this info: -- when filing a service call -- when ordering spare parts or accessories -- with technical queries Type plate After-sales service: Address: Tel.
319 3900-00 - K/RD-SD 980928
