User manual
Installation instructions
Safety instructions
ATTENTION! Please read carefully.
The laws, ordinances, directives and standards
in force in the country of use are to be followed
(safety regulations, proper recycling in accord-
ance with the regulations, etc.).
Installation may only be carried out by a quali-
fied electrician.
The minimum distances to other appliance and
units are to be observed.
Anti-shock protection must be provided by the
installation, for example, drawers may only be
installed with a protective floor directly under-
neath the appliance. The cut surfaces of the
worktop are to be protected against moisture
using a suitable sealant.
The sealant seals the appliance to the work top
with no gap.
When building in, protect the underside of the
appliance from steam and moisture, e.g. from
a dishwasher or oven.
Avoid installing the appliance next to doors and
under windows. Otherwise hot cookware may
be knocked off the rings when doors and win-
dows are opened.
WARNING!
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Observe connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing
correctly.
• The appliance must be connected to the
electrical supply by a qualified electrician.
CAUTION!
Risk of injury from electrical current.
Loose and inappropriate plug and socket con-
nections can make the terminal overheat.
• Have the clamping connections correctly in-
stalled by a qualified electrician.
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase
connection, the appropriate mains cable of
type H05BB-F Tmax 90° (or higher) must be
used.
• If this appliance's mains cable is damaged,
it must be replaced by a special cable (type
H05BB-F Tmax 90°; or higher). The latter is
available from the Customer Care Depart-
ment.
A device must be provided in the electrical in-
stallation which allows the appliance to be
disconnected from the mains at all poles with a
contact opening width of at least 3 mm.
Suitable isolation devices include line protect-
ing cut-outs, fuses (screw type fuses are to be
removed from the holder), earth leakage trips
and contactors.
59