User manual

13
fig. 1.
fig. 2.
fig. 3.
Door Reversal
Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Appliances on the market are right-handed.
Following operations are to be done on the basis of fig-
ures and explanations:
1. To perform the operations listed below it is recom-
mended to ask another person for help who safely
can hold the doors while performing the opera-
tions.
2. Disconnect the appliance from the electricity sup-
ply.
3. Open the doors and dismount the double door
hinge (a,b) by removing the screws (2 pieces) (c).
(fig. 2)
4. Take off the double door hinge (a,b,c) by gradually
removing it from the cabinet, slightly tilting both
doors. Do not forget to remove the plastic spacer
(b) under the hinge. (fig. 2)
5. Take off the refrigerator door by pulling it slightly
downwards.
6. Take off the freezer door by pulling it slightly
upwards.
7. Remove the plug on the upper side of the refrig-
erator door and put it to the other side.
8. Remove the plug on the upper side of the freezer
door and put it to the other side.
9. Unscrew the top door hinge pin (d) of the refrig-
erator then screw it back on the other side. (fig.1)
10. Remove the plugs (u) at the bottom of the appli-
ance. (fig.3)
11. Remove the lower hinge (e) by removing its
screws (s) and mount it on the other side. (fig.3)
12. Unmount the lower hinge pin (f) and its washer (h)
and mount them into the other hole of the lower
hinge. (fig.3)
13. Replace the plugs (u) on the other side.
14. Remove the covering pins (3 pieces) (n, k) of the
double door holder on the left side and put them
to the other side. (fig.2)
15. Fit the pin of the double door hinge (m) into the left
drill of the freezer door. (fig. 2)
16. Fit the freezer door to the lower door hinge pin (f).
(fig. 4)
17. Fit the refrigerator door to the upper door hinge pin
(d) then slightly tilting both doors fit the pin of the
double door hinge (m) into the left drill of the refrig-
erator door.
18. Opening both doors fix the double door hinge onto
the left side using the screws (2 pieces) (c). Do not
forget to replace the plastic spacer (b) under the
hinge. Be careful that the door edges are parallel
with the edge of the mantle.