User manual

Setting the time
You must set the time before you operate the
oven.
Only the top oven works without the
set time.
The indicator for the Time of day function
flashes when you connect the appliance to the
electrical supply, when there was a power cut
or when the timer is not set.
Press the or button to set the correct
time.
After approximately five seconds, the flashing
stops and the display shows the time of day you
set.
Changing the time
You cannot change the time of day if
the Duration or End function
operates.
Press again and again until the indicator for
the Time of Day function flashes.
To set a new time, refer to "Setting the time".
Preheating
Preheat the empty appliance to burn off the
remaining grease.
Preheat the two ovens. Heat up one
oven at a time.
Set the functions listed below, if
applicable.
1. Set the function and the temperature to
250ºC.
Let the appliance operate for 1 hour.
2. Set the function and the temperature to
250ºC.
Let the appliance operate for 15 minutes.
3. Set the function and the temperature to
250ºC.
Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
Daily use
WARNING!
Refer to Safety chapters.
Retractable knobs
To use the appliance, press the control knob.
The control knob comes out.
Activating and deactivating the top /
main oven
It depends on the model if your
appliance has knob symbols,
indicators or lamps:
• The indicator comes on when the
oven heats up.
• The lamp comes on when the
oven operates.
• The symbol shows whether the
knob controls the oven functions
or the temperature.
1. Turn the knob for the top / main oven
functions to select an oven function.
2. Turn the knob for the temperature to select
a temperature.
3. To deactivate the oven turn the knob for the
top / main oven functions to the off position.
6 www.zanussi.com