REFRIGERATOR ZR714W INSTRUCTION BOOKLET 818 14 54--04/5
Important Safety Instructions GB Your new fridge may have other functions compared to your previous one. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else.
Contents GB Instructions for the User Internal Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . External Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . Defrosting the fridge . . . . . . . . . . . . . . . . . . . . . . . . To Change the Light Bulb . . . . . . . . . . . . . . . . . . . . When the appliance is not in use . . . . . . . . . . . . . . . Important Safety Instructions . . . . . . . 2 Scrapping old cabinets . . . . . . . . . . . . . . . . . . . . . . . 3 Contents . .
Description of the Appliance 5 Model ZR714W 1 1. 1 GB 4 7 1 1 Glass shelf 2. Bottle shelf 3. Salad drawer 4. Egg tray 5. Dairy compartment + butter box 6. Ventilation grille 7. Door shelf 7 1 1 3 7 3 3 2 6 Control Panel A A. Green indicator light Illuminates when the fridge is operating. B B. Thermostat control Use to switch on and set the desired temperature in the fridge.
Before use ·Remove all securing tapes. ·Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly. Do not use detergents, abrasive powders, highly perfumed cleaning products, wax, polishes or products containing alcohol.
Measuring the temperature If the temperature is measured using a standard, single thermometer, this should be put in a glass of water centrally placed inside the cabinet. This will reflect the temperature inside the food products. Do not place the thermometer hanging or lying directly on the shelf. · · · · Distribute foodstuffs to allow cold air to circulate freely between the products. Do not place food products directly against the cooling plate on the rear wall since they may freeze in this case.
Hints and Tips GB Normal Operating Sounds · Try to avoid keeping the door open for long · You may hear faint gurgling or bubbling sounds · · when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate/evaporator. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor and you will hear a faint " click" when the termostat cuts in and out.
External Cleaning Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption.
Water is running inside the refrigerator. Clean the water drain and drain hole inside the refrigerator using e.g. cotton swabs or a bottle cleaner brush. Food products could have been placed near the rear of the appliance, preventing the water from running into the drain. Water comes out on the floor. Place the drain hose at the back of the cabinet above the drain bowl. See the chapter "Before use" The compressor operates continuously. Set a warmer temperature.
To contact your local Service Force Centre telephone 08705 CHANNEL ISLANDS GUERNSEY Guernsey Electricity PO Box 4 Vale, Guernsey Channel Islands GY1 3AD JERSEY Jersey Electricity Company Haut De L’orme Rue De Haut De L’orme Trinity Jersey Channel Islands JE3 5FG SCOTLAND ABERDEEN AUCHTERMUCHTY BLANTYRE 54 Claremont Street Aberdeen AB10 6RA 33a Burnside Auchtermuchty Fife KY14 7AJ Unit 5 Block 2 Auchenraith Ind.
To contact your local Service Force Centre telephone 08705 MIDLANDS BIRMINGHAM 66 Birch Road East Wyrley Trading Estate Witton Birmingham B6 7DB BOURNE Pinfold Road Bourne PE10 9HT BRIDGNORTH 68 St.
Customer Care Department GB Fore general enquiries concerning your Zanussi appliance or futher information on Zanussi products, please contact our Customer Care Department by letter or phone at the address below or visit our website at www.zanussi.co.uk Customer Care Department Zanussi 55-77 High Street Slough Berkshire SLI IDZ 08705 727727(*) * calls to this number may be recorded for training purposes.
after you and your appliances. France Germany Italy Sweden UK Senlis Nürnberg Prodenone Stockholm Slough +33 (0)3 44 62 22 22 +49 (0)911 323 26 00 +39 (0)1678 47053 +46 (0) 20 78 77 55 +44(0) 1753 21 98 97 Technical specification Model ZR714W Net volume 379 l Width 595 mm Height 1800 mm Depth 600 mm Energy consumption 248 kwh/year Energy class B Rated power 110 W GB * This figure is based on standard test resultd to the European Standard EN153.
Installing the cabinet To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight. · the cabinet is not placed close to a source of heat, e.g. a cooker or dishwasher. · the cabinet is level. The cabinet should not lean against any wall. If necessary adjust the feet using the adjustment spanner supplied. · there is good air circulation around the cabinet and that the air channels below and behind the cabinet are not blocked.
Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The appliance is supplied with a 13amp plug fitted.
Door Reversal 1 1. Close the cabinet and remove the plug from the electrical socket. 2 2. Remove the ventilation grille. There is a part on the grille that can be removed. Reposition it and transfer to the opposite side. 3 3. Support the cabinet on a wooden block when it is laid down. This will make it easier to grip under the cabinet when returning to an upright position. 4 4. On the upper part of the cabinet. Remove the hinge pin and replace on the other side. 5. On the lower part of the cabinet.
qÜÉ=bäÉÅíêçäìñ=dêçìé=áë=íÜÉ=ïçêäÇDë=ä~êÖÉëí=éêçÇìÅÉê=çÑ=éçïÉêÉÇ=~ééäá~åÅÉë=Ñçê=âáíÅÜÉåI=ÅäÉ~åáåÖ=~åÇ=çìíÇççê=ìëÉK jçêÉ=íÜ~å=RR=ãáääáçå=bäÉÅíêçäìñ=dêçìé=éêçÇìÅíë=EëìÅÜ=~ë=êÉÑêáÖÉê~íçêëI=ÅççâÉêëI=ï~ëÜáåÖ=ã~ÅÜáåÉëI=î~Åììã=ÅäÉ~åÉêëI ÅÜ~áå=ë~ïë=~åÇ=ä~ïå=ãçïÉêëF=~êÉ=ëçäÇ=É~ÅÜ=óÉ~ê=íç=~=î~äìÉ=çÑ=~ééêçñK=rpa=NQ=Äáääáçå=áå=ãçêÉ=íÜ~å=NRM=ÅçìåíêáÉë ~êçìåÇ=íÜÉ=ïçêäÇK Mariestad KTD--AV
