User manual

Problem Possible cause Solution
The product temperature is too
high.
Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.
During the automatic defrosting
process, frost defrosts on the rear
plate.
This is correct.
Water flows into the refrig-
erator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water flows
into the water collector.
Make sure that products do not touch
the rear plate.
There is too much frost
and ice.
Products are not wrapped properly. Wrap the products better.
The door is not closed correctly. Refer to "Closing the door".
The Temperature regulator may be
set incorrectly.
Set a higher temperature.
The temperature in the ap-
pliance is too low.
The Temperature regulator may be
set incorrectly.
Set a higher temperature.
The temperature in the ap-
pliance is too high.
The Temperature regulator may be
set incorrectly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time.
Store less products at the same time.
The temperature in the re-
frigeration is too high.
There is no cold air circulation in the
appliance.
Make sure that there is cold air circu-
lation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each other. Store products so that there is cold
air circulation.
The appliance does not op-
erate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to
the mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
If your appliance is still not working properly af-
ter making the above checks, contact the After
Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
10
www.zanussi.com