Operation Manual

Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the docu-
mentation, there are two
spacers which must be fit-
ted as shown in the figure.
Using fine strokes of ham-
mer put them in their
place.
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm .
Ideally, however, the appliance should not be positioned
below overhanging wall units. Accurate levelling is ensur-
ed by one or more adjustable feet at the base of the cabi-
net.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.
Warning! It must be possible to disconnect the ap-
pliance from the mains power supply; the plug must
therefore be easily accessible after installation.
~10 cm
AB
~2,5 cm ~2,5 cm
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
To change the opening direction of the door, do these
steps:
18